Rocker Shaft - Disassemble
Disassembly Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1P-0510     | Driver Group     | 1     |
Start By:
- Remove the rocker shaft assembly. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Remove".
- Use a screwdriver or a similar tool to remove retaining ring (1) from both ends of the rocker shaft assembly.
Show/hide table
Illustration 1 | g00550061 |
- Remove the rocker arms and the rocker shaft brackets from the rocker shaft assembly.
Note: Place an identification mark on each of the components for the proper order for installation.
Show/hide table
Illustration 2 | g00550062 |
(1) Retaining ring (2) Washer on the end of the rocker shaft (3) Rocker arm assembly (4) Rocker shaft bracket (5) Spring on the rocker shaft (6) Washer (7) Rocker shaft (8) Bolt (9) Oil supply connection (10) Rocker arm bushing |
- Check the clearance between rocker arm assembly (3) and rocker shaft (7). Replace rocker arm bushing (10) if the clearance is larger than 0.13 mm (0.005 inch). Use Tool (A) and a suitable press in order to remove rocker arm bushing (10) from rocker arm assembly (3), if necessary.
- Remove rocker shaft bracket (4) from rocker shaft (7) .
- Remove springs (5), washer (6), bolt (8) and oil supply connection (9) from rocker shaft (7) .
Caterpillar Information System:
3054 Truck Engine Rocker Shaft and Pushrod - Install
SR4 HV and SR4B HV Generators Walk-Around Inspection
3054 Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
3054 Engine for Caterpillar Built Machines Housing (Front) - Install
3054 Engine for Caterpillar Built Machines Housing (Front) - Remove
SR4 HV and SR4B HV Generators Before Starting Engine
Generator Set Control Panel for Switchgear Conversion Component Location
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Remove
3408E and 3412E Engines for Caterpillar Built Machines Fuel Transfer Pump
3606 and 3608 Engines General Information (Lubrication System)
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Disassemble
Generator Set Control Panel for Switchgear Conversion Clear/Mode Switch - Troubleshoot
Generator Set Control Panel for Switchgear Conversion Cycle Crank - Adjust
3408E and 3412E Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Assemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank
3054 Truck Engine Cylinder Head - Remove - 3054 and 3054B Engines
3054 Truck Engine Cylinder Head - Install - 3054 and 3054B Engines
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Assemble
G3408 and G3412 Engines Actuator Linkage
G3408 and G3412 Engines Carburetor Control Linkage
G3606 and G3608 Engines Engine Oil Pump - Install
G3408 and G3412 Engines Magnetic Pickup
G3606 and G3608 Engines Engine Oil Pump - Disassemble