| NOTICE |
|---|
Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage. |
Stop the engine in order to check the oil level. DO NOT check the oil level when the engine is running.
Park the machine on a level surface.
- Open the access door for the engine compartment.
 | |
| Illustration 1 | g00885638 |
- Remove the dipstick. Wipe the dipstick with a clean cloth. Insert the dipstick. Remove the dipstick and note the oil level. Insert the dipstick.
Note: Refer to the Operation and Maintenance Manual, "Lubricant Viscosities and Capacities (Refill)" for the proper viscosity and the correct amount of oil that is used when the oil is changed.
 | |
| Illustration 2 | g00885651 |
- Maintain the oil level on the dipstick between the FULL RANGE mark and the ADD OIL mark. Add oil if the oil level is too low.
Note: Operating your engine with the oil level above the FULL mark in the FULL Range could cause the crankshaft to dip into the oil. This could result in excessively high operating temperatures. The high operating temperatures could result in reduced lubricating characteristics of the oil. This could cause damage to the bearings and loss of engine power.
 | |
| Illustration 3 | g00762225 |
Add The Engine Oil
- Open the engine compartment.
- Remove the oil filler plug.
 | |
| Illustration 4 | g00885660 |
- Add the oil.
- Clean the oil filler plug. Install the oil filler plug.
- Close the engine compartment.