 | |
| Illustration 1 | g00350737 |
Typical Illustration (1) Bevel pinion (2) Bevel gear (3) Ring gear (4) Planetary gear (5) Carrier (6) Axle shaft (7) Spider (8) Differential case (9) Pinion (10) Side gear (11) Brake piston (12) Brake disc (13) Sun gear | |
The front axle group and the rear axle group incorporate the pinion and bevel gear set, the differential, the final drives, and the disc brakes. The front axle housing and the rear axle housing are slightly different, but the internal components and the operation are identical. A limited slip differential is available in both the front axle group and the rear axle group. A NoSPIN differential is available in the rear axle group.
Power from the transmission output shaft is transferred to the front axle group and to the rear axle group by the drive shafts. The power enters the axle groups through bevel pinion (1). Bevel pinion (1) turns bevel gear (2). Bevel gear (2) is fastened to differential case (8) .
Power is transferred through the differential by pinions (9) and by side gears (10) to the final drives. The following components are the main components of the final drives: carrier (5), planetary gears (4), ring gear (3) and sun gear (13). Each final drive has the same components. The final drives cause the last speed reduction and the last torque increase in the drive train.
Sun gear (13) is splined into side gear (10) of the differential. Ring gear (3) is pressed into the axle housing. Three planetary gears (4) are mounted in carrier (5). Carrier (5) has internal splines. The splines of axle shaft (6) fit into the splines of carrier (5) .
As sun gear (13) is driven by the differential, planetary gears are forced to revolve around the inside of ring gear (3). The movement of planetary gears (4) around ring gear (3) causes carrier (5) and axle shaft (6) to rotate. This transfers power to the rim and the tire. The rim and the tire bolt to the flange on axle shaft (6) .
The axle groups contain the service brakes. Brake disc (12) is splined to sun gear shaft (13). Brake disc (12) rotates at the same speed as the sun gear. When the brakes are applied, the cavity behind brake piston (11) is pressurized. When the brakes are applied, the brake piston clamps brake disc (12) between the piston and the brake reaction plate.
Reference: For additional information about the braking system, refer to the following service manuals: Specifications, RENR4315, "950G Series II Wheel Loader, 962G Series II Wheel Loader, and IT62G Series II Integrated Toolcarrier Braking System", Systems Operation, RENR4316, "950G Series II Wheel Loader, 962G Series II Wheel Loader, and IT62G Series II Integrated Toolcarrier Braking System" and Testing and Adjusting, RENR4317, "950G Series II Wheel Loader, 962G Series II Wheel Loader, and IT62G Series II Integrated Toolcarrier Braking System".