Aftercooler - Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
注: 检查密封垫和 O 形圈的状况。 如果密封垫或 O 形圈磨损或损坏,则用新零件更换。
- 如果密封垫已拆下,则安装后冷器壳体的密封垫 (25)。
Show/hide table
图 2 g00579413 典型实例 - 安装先前拆下的后冷器壳体 (23)。
- 安装螺栓 (24) 和垫圈。
Show/hide table
图 3 g00579412 典型实例 - 安装 O 形密封圈 (22)。
- 利用甘油轻轻润滑后冷器壳体内孔和 O 形圈 (22)。
- 安装后冷器芯 (21)。 使用后冷器芯上的起重支架和适当的起吊设备。
后冷器芯组件的重量约为
26 kg (57 lb) 。Show/hide table图 4 g00579409 典型实例 - 安装过渡接头 (16) 和 O 形密封圈 (17)。
- 安装过渡接头 (18) 和 O 形密封圈。
- 利用螺栓 (20) 安装弯头 (19)。
Show/hide table
图 5 g00579407 典型实例 - 安装螺栓 (15) 和垫圈。
Show/hide table
图 6 g00579404 典型实例 - 安装后冷器盖 (14)。
- 安装夹子 (12)、托架 (11) 和螺栓 (13)。
- 利用螺栓 (9) 和 O 形密封圈安装弯头 (10)。
Show/hide table
图 7 g00579403 典型实例 - 利用螺栓 (7) 安装卸压阀壳体 (6)。
- 连接燃油管 (8)。
Show/hide table
图 8 g00579401 典型实例 - 利用螺栓 (3) 安装弯头 (4)。
- 连接燃油管 (1)。
- 将螺栓 (2) 和垫圈安装到夹子内。
- 安装螺栓 (5)、垫圈和隔套。
Show/hide table
图 1 | g00579418 |
典型实例 |
- 将新 O 形密封圈 (21) 安装到弯头 (8) 和 (10) 内。
Show/hide table
图 10 g00714016 - 由两人定位后冷器 (20) 及其托架 (12) 和 (15)。 后冷器和托架的重量约为
43 kg (95 lb) 。Show/hide table图 11 g00714007 - 将卡箍 (19) 卡到软管上并利用螺栓 (18) 安装卡箍 (19)。
Show/hide table
图 12 g00714001 - 将四条螺栓 (17) 和垫圈安装到后冷器底部。
Show/hide table
图 13 g00713996 - 将螺栓 (16) 安装到左侧后冷器的底部。
- 将两条螺栓 (14) 和垫圈安装到后冷器左侧的支架 (15) 上。
Show/hide table
图 14 g00713992 - 将螺栓 (13) 安装到右侧后冷器的底部。
Show/hide table
图 15 g00713977 - 将两条螺栓 (11) 和垫圈安装到后冷器右侧的支架 (12) 上。
Show/hide table
图 16 g00714031 - 将四条螺栓 (7) 安装到后冷器前端的弯头 (8) 上。
- 将四条螺栓 (9) 安装到后冷器前端的弯头 (10) 上。
Show/hide table
图 17 g00713974 - 定位带有新密封垫的管组件 (6)。
- 安装螺栓 (5) 和板。
- 安装三个螺栓 (4)。
Show/hide table
图 18 g00713966 - 定位带有新密封垫的管组件 (3)。
- 安装螺栓 (2) 和板。
- 安装三个螺栓 (1)。
Show/hide table
图 9 | g00714041 |
结束:
- 为发动机加注冷却液。 请参阅操作和保养手册, "冷却系统冷却液 - 更换"以了解正确步骤。
Caterpillar Information System:
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Bank Valve (Four)(Mechanically Operated)
3408E and 3412E Engines for Caterpillar Built Machines Aftercooler - Remove
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Machine Does Not Move
768C, 769C, 769D, 772B, 773B, 773D, 776C, 777B, 777D, 784B, 785, 785B, 789, 789B, 793, 793B and 793C Off-Highway Truck/Tractors and 771C, 771D and 775D Quarry Trucks Automatic Retarder Control (ARC) System CID 0190 FMI 02 Speed Sensor (Engine) Incorrect Signal - Test
950G Series II Wheel Loader, 962G Series II Wheel Loader and IT62G Series II Integrated Toolcarrier Power Train Fixed Axle and Oscillating Axle
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System System Power
2001/11/12 Corrections to Disassembly and Assembly , "Inlet and Exhaust Valve Guides - Remove and Install" {1104}
2001/11/26 Puller Holes Have Been Added to Gear Assemblies for the Transmission {3061}
TH210 and TH215 Telehandlers Power Train General Information
735 Articulated Truck Power Train Rear Axle - Remove
950G Series II Wheel Loader, 962G Series II Wheel Loader and IT62G Series II Integrated Toolcarrier Power Train Output Transfer Gears
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Pilot Valve (Joystick)
950G Series II and 962G Series II Wheel Loaders and IT62G Series II Integrated Toolcarrier Power Train Parking Brake - Remove
950G Series II and 962G Series II Wheel Loaders and IT62G Series II Integrated Toolcarrier Power Train Parking Brake - Install
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Bank Valve (Four)(Mechanically Operated)
797 Off-Highway Truck Engine Oil Pan Sump Screen - Inspect/Clean
950G Series II Wheel Loader, 962G Series II Wheel Loader and IT62G Series II Integrated Toolcarrier Power Train Transmission Planetary
2006/08/14 Changes to the Steer Linkage Improve the Service Life {4305}
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Bank Valve (Four)(Mechanically Operated)
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Bank Valve (Four)(Mechanically Operated)
768C, 769C, 769D, 772B, 773B, 773D, 776C, 777B, 777D, 784B, 785, 785B, 789, 789B, 793, 793B and 793C Off-Highway Truck/Tractors and 771C, 771D and 775D Quarry Trucks Automatic Retarder Control (ARC) System CID 0190 FMI 09 Speed Sensor (Engine) Abnormal Update - Test
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Bank Valve (Four)(Mechanically Operated)
2001/10/22 Correction to Testing and Adjusting , "Transmission Pressures - Test and Adjust" {3030, 3030}
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Bank Valve (Four)(Mechanically Operated)