Steering Frame Lock
Show/hide table
 |
|
No clearance for person in this area when machine turns. Severe injury or death from crushing could occur. |
Install the steering frame lock pin between the front frame and the rear frame before you lift the machine and before you transport the machine on another vehicle. Also install the steering frame lock pin before you perform maintenance near the center of the machine.
In order to install the steering frame lock pin, the machine must be in the straight ahead position.
- Apply the parking brake.
- Turn the engine start switch key to the OFF position. Remove the key.
Show/hide table
Illustration 1 g00353153 - After the machine has been moved into position, install the steering frame lock pin. The pin will hold the front frame and the rear frame rigid. Remove pin (2). Lower steering frame lock pin (1). Reinstall pin (2).
- In order to unlock the steering frame, reverse the steps that are used to lock the steering frame.
Caterpillar Information System:
2001/10/15 A New Solenoid Valve Is Used for Priority Valves {5479}
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System MID 079 - CID 0367 - FMI 02
2001/12/03 New Relays and New Panel Seals are now Available {7451}
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System MID 079 - CID 0347 - FMI 06
TK1051 Track Feller Buncher Machine Systems Main Control Valve - Assemble
740 EJECTOR Articulated Truck Cooling System Pressure Cap - Clean/Replace
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Extendable Stick Cylinder
TL5 Series Field Cultivator General Information
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System MID 079 - CID 0347 - FMI 05
Operation of the Machine Security System{7631} Operation of the Machine Security System{7631}
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Stick Cylinder
2002/10/21 A Revised Counterweight Group Is Now in Production {7056}
2002/05/20 Correction to Disassembly and Assembly Manual , "Front Wheel Bearing - Install" {4201}
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Extendable Stick Cylinder
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System MID 079 - CID 0390 - FMI 03
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System MID 079 - CID 0390 - FMI 05
2001/12/03 Correction to Service Magazine , "Circle Drive can be Modified to Improve Performance" {5207}
Providing A Power Source to the Control Device for Snowblowers{1408, 6715, 7000} Providing A Power Source to the Control Device for Snowblowers{1408, 6715, 7000}
CP-563C and CS-563C Vibratory Compactors Platform Tilting
TL5 Series Field Cultivator Implement Attaching
3126B Engine for Caterpillar Built Machines Electric Starting Motor
966G Series II Wheel Loader and 972G Series II Wheel Loader Machine Systems Evaporator Coil and Heater Coil - Remove
TL5 Series Field Cultivator Implement Detaching
3176C and 3196 Engines for Caterpillar Built Machines Low Power/Poor or No Response to Throttle