826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Caterpillar


Transmission Oil Filter - Replace

Usage:

824G II AWW


NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.

Dispose of all fluids according to local regulations and mandates.


  1. Open the small access door. The transmission oil filter is located on the right side of the machine.


    Illustration 1g00768695

  2. Open the shutoff valve (2) and allow the oil to drain into a suitable container.

  3. Use a strap type wrench in order to remove the transmission filter housing (1).

  4. Remove the used transmission oil filter element. Dispose of the used filter element properly.

  5. Clean the transmission filter housing in a clean, nonflammable solvent. Clean the filter housing base.

  6. Inspect the filter housing seal. Replace the seal if the seal is damaged.

  7. Insert a new transmission oil filter element into the transmission filter housing.

  8. Close the shutoff valve. Install the transmission filter housing into the filter housing base. Tighten the transmission filter housing by hand.

  9. Start the engine. Apply the service brakes.

  10. Slowly operate the transmission controls in order to circulate the transmission oil. Return the transmission to NEUTRAL.

  11. Engage the parking brake. Inspect the transmission oil filter for leaks.

  12. Stop the engine.

  13. Check the transmission oil level.

    Reference: Refer to Operation and Maintenance Manual, "Transmission Oil Level - Check" for the correct procedure.

Caterpillar Information System:

3500 Generator Set Engines Engine Oil Pressure - Test
CP-663E, CS-663E and CS-683E Vibratory Compactors Propel System Machine Preparation for Troubleshooting
CP-663E, CS-663E and CS-683E Paving Compactors Machine Systems Steering Hydraulic System
725 and 730 Articulated Trucks Machine Systems Piston Pump (Brake) - Install
826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Transmission Oil - Change
2001/01/29 Improvements have been made to the Steering Column {4338}
236, 246, 252 and 262 Skid Steer Loaders Machine Systems Piston Pump (Hydrostatic)
216 and 226 Skid Steer Loaders Machine Systems Piston Motor (Hydrostatic)
3524B Engines for 797 and 797B Off-Highway Trucks Cylinder Heads
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Machine Systems Steering Metering Pump - Disassemble
CP-663E, CS-663E and CS-683E Vibratory Compactors Vibratory System Relief Valve (Main) - Test and Adjust
2001/01/29 The Ladder Support for the Pipelayer Is Improved {7254}
CP-663E, CS-663E and CS-683E Vibratory Compactors Propel System Visual Inspection
CP-663E, CS-663E and CS-683E Paving Compactors Machine Systems Machine Preparation for Troubleshooting
2001/01/29 Rework Process for Exhaust Manifolds {1059}
2001/01/29 A New Guard Is Used on the Wiring Harness of Wheel Harvesters {7150}
826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Transmission Oil Level - Check
216, 226 and 228 Skid Steer Loaders Engine Supplement Gear Motor (Fan) - Remove
CP-663E, CS-663E and CS-683E Vibratory Compactors Vibratory System Case Drain Flow for Piston Motor - Test and Adjust
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Machine Systems Steering Metering Pump - Assemble
725C2 and 730C2 Articulated Truck Machine System Pump Control Valve (Brake) - Remove and Install
826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Window Washer Reservoir - Fill
2001/02/19 A New Hose is used on the Pitot Tube in the Ventilation System on the Paver {6654}
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B andBarber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Pump Drive - Remove
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.