CP-663E, CS-663E and CS-683E Vibratory Compactors Propel System Caterpillar


Visual Inspection

Usage:

CS-663E AEF

------ WARNING! ------

即使是从针孔大小的渗漏中漏出的空气或液体,都能够穿透人体组织而造成严重创伤,甚至死亡。 如果液体喷射穿透进您的皮肤,必须立即找熟悉这类型创伤的医生处置。

检查渗漏时,请务必使用木板或硬纸板作为挡板。


------ WARNING! ------

滚热的油或液压油的压力会对人员造成伤害。

发动机停机之后,液压油的压力仍会保留在液压系统里。 对液压系统进行维修之前,如果不事先释放压力,可能会造成严重伤害。

卸下机具和其油路之前,必须先把机具放到地面上,让油先冷却,才可进行工作。 只能在发动机停机,并且加注口盖冷却到可以用徒手触摸时才能卸下加注口盖。



注意

在检验、保养、测试、调整及维修产品时,务必留心,确保液体盛装在容器中。 在打开任何腔室或拆解任何储有液体的部件之前,要准备好用合适的容器收集液体。

有关适合收集和盛接卡特彼勒产品上液体的工具及用品,参考专门出版物, NENG2500, "卡特彼勒工具和修理车间设备指南"。

按照当地法规和指令处置所有液体。


诊断故障时先要进行目视检查。 进行这些检查前,应停运发动机并接合停车制动器。 将推进操纵杆移到空档位置。 在检查过程中,如果必要,用磁铁将铁质颗粒物(铁)与非铁质颗粒物(O 形密封圈、铝、青铜等)分离开来。

  1. 检查液压油箱的油位。

  1. 机器停止后,立即检查油中是否有气泡或油中是否含水。 利用清洁的油瓶或容器获取油样。 有关推荐的油品等级和粘度,请参阅操作和保养手册, "润滑剂粘度和加注容量"。

    1. 气泡可能是由于接头松动或损坏造成的。 松动或损坏的接头将使空气进入系统的吸油侧,油也会发生泄漏。

  1. 检查所有的油管、软管和接头是否发生损坏或泄漏。 从地面看机器底部是否有油迹。

    注: 如果管接头或接头漏油,空气可能会进入系统内。 系统中的空气与油量过少的危害一样。

Caterpillar Information System:

826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Transmission Oil Filter - Replace
3500 Generator Set Engines Engine Oil Pressure - Test
CP-663E, CS-663E and CS-683E Vibratory Compactors Propel System Machine Preparation for Troubleshooting
CP-663E, CS-663E and CS-683E Paving Compactors Machine Systems Steering Hydraulic System
725 and 730 Articulated Trucks Machine Systems Piston Pump (Brake) - Install
826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Transmission Oil - Change
2001/01/29 Improvements have been made to the Steering Column {4338}
236, 246, 252 and 262 Skid Steer Loaders Machine Systems Piston Pump (Hydrostatic)
216 and 226 Skid Steer Loaders Machine Systems Piston Motor (Hydrostatic)
3524B Engines for 797 and 797B Off-Highway Trucks Cylinder Heads
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Machine Systems Steering Metering Pump - Disassemble
CP-663E, CS-663E and CS-683E Vibratory Compactors Vibratory System Relief Valve (Main) - Test and Adjust
CP-663E, CS-663E and CS-683E Paving Compactors Machine Systems Machine Preparation for Troubleshooting
2001/01/29 Rework Process for Exhaust Manifolds {1059}
2001/01/29 A New Guard Is Used on the Wiring Harness of Wheel Harvesters {7150}
826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Transmission Oil Level - Check
216, 226 and 228 Skid Steer Loaders Engine Supplement Gear Motor (Fan) - Remove
CP-663E, CS-663E and CS-683E Vibratory Compactors Vibratory System Case Drain Flow for Piston Motor - Test and Adjust
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Machine Systems Steering Metering Pump - Assemble
725C2 and 730C2 Articulated Truck Machine System Pump Control Valve (Brake) - Remove and Install
826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Window Washer Reservoir - Fill
2001/02/19 A New Hose is used on the Pitot Tube in the Ventilation System on the Paver {6654}
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B andBarber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Pump Drive - Remove
CP-663E, CS-663E and CS-683E Vibratory Compactors Vibratory System Vibratory Frequency - Test and Adjust
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.