725, 730, 735, 740 and 740 EJECTOR Articulated Trucks Power Train Electronic Control System Caterpillar

This diagnostic code is recorded when the Transmission/Chassis ECM does not receive the expected information from the Caterpillar Monitoring System via the CAT Data Link.

The possible causes of this diagnostic code are listed:

• The software that is installed on the engine ECM is incorrect.

• The software that is installed on the transmission/chassis ECM is incorrect.

• The software that is installed on the Caterpillar Monitoring System is incorrect.

Note: Ensure that the CID 0562 FMI 12 for the Caterpillar Monitoring System ECM is active.

As a result of this diagnostic code, some features of the transmission/chassis ECM may not work correctly.

Test Step 1. VERIFY THE SOFTWARE PART NUMBERS.

1. Connect the ET to the machine.

2. Start the ET software and proceed to the ECM summary screen.

3. Verify that the following information is correct:
   • The software part number for the transmission/chassis ECM

   • The software part number for the engine ECM

   • The software part number for the Caterpillar Monitoring System ECM

   Note: Consult the business unit that produces the product for the correct part numbers for the software.

Expected Result:

All of the software part numbers are correct.

Results:

• OK - All of the software part numbers are correct. Proceed to test step 2.

• NOT OK - One or more of the software part numbers are NOT correct.

  Repair: Flash the correct software. See Testing and Adjusting, "Electronic Control Module (ECM) - Flash Program".

  Stop.

Test Step 2. VERIFY THAT THE MACHINE MODEL IS CORRECT.

Note: The information for the harness code plug for the Caterpillar Monitoring System is sent to the transmission/chassis ECM via the CAT data link. The harness code plug determines the appropriate sales model. Therefore, an incorrect harness code can cause incorrect diagnostics to be logged.

1. The ET will remain connected to the machine.

2. Verify that the machine model that is reported from the ECM summary screen agrees with the actual machine model.

Expected Result:

The machine model matches.

Results:

• OK - The machine model matches. Proceed to test step 3.

• NOT OK - The machine model does NOT match. The harness code of the Caterpillar Monitoring System may be incorrect.

  Repair: Correct the harness code of the Caterpillar Monitoring System.

  If conditions are not resolved proceed to test step 3.

Test Step 3. VERIFY THAT THE DIAGNOSTIC CODE IS PRESENT.

1. The ET will remain connected to the machine.

2. Select the transmission ECM from the ECM summary screen.

3. Check whether CID 0562 FMI 12 is present.

Expected Result:

The CID 0562 FMI 12 is NOT present.

Results:

• OK - The diagnostic code is NOT present. The initial diagnostic code was probably caused by a poor electrical connection at the Caterpillar Monitoring System harness code lines. There could have been a short at one of the harness connectors that was disconnected and then reconnected. Stop.

• NOT OK - It is unlikely that the ECM for the Caterpillar Monitoring System has failed.

  Repair: Exit this procedure and perform this CID 0562 FMI 12 again. If the cause of the diagnostic code is not found, replace the ECM for the Caterpillar Monitoring System. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace.".

  Stop.