IT28G Integrated Toolcarrier Caterpillar

Note: All safety information, warnings, and instructions must be read and understood before you perform any operation or any maintenance procedure.

Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed.

The conditions for the engine oil change interval are described in the Operation and Maintenance Manual, "Engine Oil and Filter - Change" .

Refer to the results of the S·O·S oil analysis in order to determine if the oil change interval should be decreased to 250 hours or 125 hours. Consult your Caterpillar Dealer for detailed information regarding the optimum oil change interval.

When Required

Air Conditioner Condenser - Clean
Battery - Recycle
Battery Electrolyte Level - Check
Battery, Battery Cable or Battery Disconnect Switch - Replace
Bucket Cutting Edges - Inspect/Replace
Bucket Tips - Inspect/Replace
Bucket Wear Plates - Inspect/Replace
Circuit Breakers and Fuses - Reset/Replace
Engine Air Filter Primary Element - Clean/Replace
Engine Air Filter Secondary Element - Replace
Engine Air Filter Service Indicator - Inspect
Engine Air Precleaner - Clean
Fuel System Priming Pump - Operate
Fuel Tank Water and Sediment - Drain
Oil Filter - Inspect
Radiator Core - Clean
Window Washer Reservoir - Fill
Window Wiper - Inspect/Replace

Every 10 Service Hours or Daily

Backup Alarm - Test
Cab Air Filter - Clean/Replace
Cooling System Level - Check
Differential Oil Level - Check
Engine Oil Level - Check
Fuel System Water Separator - Drain
Hydraulic System Oil Level - Check
Seat Belt - Inspect
Tire Inflation - Check
Transmission Oil Level - Check
Walk-Around Inspection
Windows - Clean

Every 100 Service Hours or 2 Weeks

Attachment Arm and Cylinder Linkage - Lubricate
Axle Oscillation Bearings - Lubricate
Steering Cylinder Bearings - Lubricate

Every 250 Service Hours or Monthly

Air Conditioner - Test
Battery - Inspect
Braking System - Test
Cooling System Coolant Additive (DEAC) - Add
Drive Shaft Spline (Center) - Lubricate
Drive Shaft Support Bearing - Lubricate
Engine Crankcase Breather - Clean
Fuel Tank Cap and Strainer - Clean
V-Belts - Inspect/Adjust/Replace

Every 500 Service Hours or 3 Months

Engine Oil and Filter - Change
Fuel System Primary Filter - Replace
Fuel System Water Separator Element - Replace
Hydraulic System Oil Filter - Replace
Transmission Oil Filter - Replace

Every 1000 Service Hours or 6 Months

Articulation Bearings - Lubricate
Rollover Protective Structure (ROPS) - Inspect
Transmission Magnetic Screen - Clean
Transmission Oil - Change

Every 2000 Service Hours or 1 Year

Brake Discs - Check
Differential Oil - Change
Engine Governor Screen - Inspect/Clean/Replace
Engine Valve Lash - Check
Fuel Injection Timing - Check
Hydraulic System Oil - Change

Every 3000 Service Hours or 2 Years

Cooling System Coolant (DEAC) - Change
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Clean/Replace

Every 6000 Service Hours or 4 Years

Cooling System Coolant (ELC) - Change