Front Wheel, Bearing and Duo-Cone Seal - Remove
Show/hide table
所需工具 | |||
---|---|---|---|
工具 | 零件号 | 零件说明 | 数量 |
A | 138-7574 | 连杆支架 | 1 |
B | 138-7576 | 连杆支架 | 1 |
C | 3S-6224 | 液压泵 | 1 |
1U-5197 | 气缸 | 1 | |
6V-6178 | 拉拔器板 | 2 | |
6V-6179 | Bar | 3 | |
1D-4635 | 螺栓 | 8 | |
5P-8250 | 硬垫圈 | 8 | |
D | 3/8 in - 16 NC | 顶出螺钉 | |
E | 5/8 in - 11 UNJC 2A | 顶出螺钉 |
开始:
- 安装液压夹钳行车制动器。 请参阅拆解和组装 , "液压夹钳行车制动器 - 拆卸"。
Show/hide table
注意 |
---|
在检查、保养、测试、调整及维修产品时,请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前,请准备好盛接液体用的适当容器。 |
注: 以下程序对于机器两侧完全相同。 必要时,对机器的另一侧重复此程序。
- 将适当的容器置于前轮下。 拆卸排放塞 (3) 和铜垫圈。 将前轮中的润滑油排入合适的容器中,以便保存或弃置。 前轮的容量为
2.4 L (0.63 US gal) 。 - 从前轮上拆卸螺栓 ( 1) 和盖 (2)。
注: 可能有必要使用工具 ( D) 拆卸盖 (2)。
Show/hide table图 2 g00509754 - 从盖 (2) 上拆下 O 形密封圈 (4)。
Show/hide table
图 3 g00509755 - 将工具 (A) 连接至前轮 ( 5)。
- 将工具 (B) 连接至前轮 ( 5)。
- 将适当的吊索绕在工具 ( A) 周围,并将适当的吊索绕在工具 ( B) 周围,如图所示。 将吊索连接至适当的举倾机构上。
Show/hide table
图 4 g00509757 - 拆下螺栓 (6)、挡圈 ( 7) 和垫片。
注: 可能有必要使用工具 ( E) 拆卸挡圈 (7)。
- 从前轮 (5) 上卸下滚柱轴承内圈 ( 8)。
- 拆下前轮 (5)。 前轮 (5) 和盘的重量为
262 kg (580 lb) 。Show/hide table图 5 g00509759 - 将滚柱轴承内圈 ( 9) 从轴上拆下。
Show/hide table
图 6 g00509760 - 将 Duo-Cone 密封 ( 10) 和密封圈从挡圈 ( 11) 上拆下。
- 从轴上拆下挡圈 ( 11)。
Show/hide table
图 7 g00509762 - 从挡圈 (11) 上拆下 O 形密封圈 (12)。
Show/hide table
图 8 g00509763 - 将 Duo-Cone 密封 ( 13) 和密封圈从前轮 ( 5) 上拆下。
- 将螺栓 (15) 从前轮 ( 5) 上拆下。
- 由两名人员一起将盘 ( 16) 从前轮 (5) 上拆下。 盘 (16) 的重量约为
38 kg (84 lb) 。 - 从前轮 (5) 上卸下两个滚柱轴承外圈 ( 14)。
Show/hide table
图 9 g00509764 - 拆下螺栓 (17)。 由两个人一起拆下板 ( 18)。 板 (18) 的重量大约为
27 kg (59 lb) 。Show/hide table图 10 g00553435 - 如图所示,将适当的吊索绕转向臂 ( 19) 安置。 将吊索固定到适当的起重机上。
- 从轴上拆下螺栓 ( 20) 并降低转向臂 (19 )。
Show/hide table
图 11 g00553441 Show/hide table为了防止人身伤害,不要以圆周以外的方式一次松开螺栓半圈以上, 任何其它方式可能会导致螺栓碎裂,从而导致人身伤害。
- 松开螺栓 (21) 半圈,然后操作下一个螺栓。 松开螺栓一圈。
- 将适当的起吊设备连接在轴上。 将起吊设备固定到适当的起重机上。
- 拆下螺栓 (21)、板 ( 22) 和垫片。
Show/hide table
图 12 g00596798 - 将工具 (C) 连接至轴。 使用工具 (C) 将轴拉出前悬架油缸的锥形面。 从前悬架油缸降下轴。 车轴和工具 (C) 的重量约为
234 kg (520 lb) 。
Show/hide table
图 1 | g00509748 |
Caterpillar Information System:
527 Track-Type Skidder Power Train Drive Shaft
527 Track-Type Skidder Power Train Bevel and Transfer Gears
784C and 785C Off-Highway Trucks Machine Systems Cab - Remove
527 Track-Type Skidder Backup Alarm
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Implement, Steering and Brake Hydraulic Systems Steering System Check
583R Pipelayer Power Train Steering Clutches and Brakes
527 Track-Type Skidder Electronic Monitoring System (EMS)
3126 Truck Engine Engine Oil Temperature Sensor
527 Track-Type Skidder Ether Starting Aid - If Equipped
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) Cable Connections
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Master Cylinder - Remove and Install
527 Track-Type Skidder Battery Disconnect Switch
784C, 785C and 785C HAA Off-Highway Truck Air System and Brakes Air Control Valve (Pulled Unit)
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) Off-Board Service Tool
D250E Series II and D300E Series II Articulated Trucks Power Train Retarder Hydraulic Control Valve - Assemble
773D Off-Highway Truck and 775D Quarry Truck Transfer Gears
773D, 773E, 775D and 775E Off-Highway Trucks Machine Systems Hydraulic Caliper Service Brake - Install
773D, 773E, 775D and 775E Off-Highway Trucks Machine Systems Front Wheel, Bearing and Duo-Cone Seal - Install
D250E Series II and D300E Series II Articulated Trucks Power Train Retarder Solenoid Control Valve - Remove
D250E Series II and D300E Series II Articulated Trucks Power Train Retarder Solenoid Control Valve - Install
D250E Series II and D300E Series II Articulated Trucks Power Train Retarder Solenoid Control Valve - Disassemble
773D, 773E, 775D and 775E Off-Highway Trucks Machine Systems Front Suspension (Cylinder) - Remove
D250E Series II and D300E Series II Articulated Trucks Power Train Retarder Solenoid Control Valve - Assemble
773D, 773E, 775D and 775E Off-Highway Trucks Machine Systems Front Suspension (Cylinder) - Install