824G , 825G and 826G Landfill Compactor Caterpillar

Illustration 1	g00504961

Illustration 2	g00504983

The power guard control is located under the access cover on the left rear side of the machine.

The power guard control opens the bottom guards for easier access for cleaning.

Illustration 3	g01099793

1. Position a jack under the transmission guard in order to lower the guard. The head of the jack should be touching the guard.

2. Remove the bolts from the transmission guard.

3. Lower the jack 25 mm (1 inch).

4. If the transmission guard lowers completely with the jack, it is possible that the actuator has failed. Use the jack to support the guard and lower the guard to the ground. If the transmission guard remains in place above the jack, remove the jack and move switch (1) downward in order to lower the transmission guard.

5. Lower the guard to the lowest position.

6. Move the switch upward in order to raise the guard.

7. Position a jack under the guard prior to replacing the bolts. The head of the jack should be touching the guard.

8. Install the bolts.

9. Remove the jack from the radiator guard.

Illustration 4	g01099798

1. Position a jack under the transmission guard in order to lower the guard. The head of the jack should be touching the guard.

2. Remove the bolts from the transmission guard.

3. Lower the jack 25 mm (1 inch).

4. If the transmission guard lowers completely with the jack, it is possible that the actuator has failed. Use the jack to support the guard and lower the guard to the ground. If the transmission guard remains in place above the jack, remove the jack and move switch (1) downward in order to lower the transmission guard.

5. Lower the guard to the lowest position.

6. Move the switch upward in order to raise the guard.

7. Position a jack under the guard prior to replacing the bolts. The head of the jack should be touching the guard.

8. Install the bolts.

9. Remove the jack from the radiator guard.