Sheave Block (Lower) - Assemble
Assembly Procedure
- Lower the temperature of sleeve bearing (14) and install a new sleeve bearing in each of the sheave assemblies. After installation of the sleeve bearings, the inside diameter of the sleeve bearings must be 82.514 ± 0.075 mm (3.2486 ± 0.0030 inch).
Show/hide table
Illustration 1 | g00501819 |
- Put yoke assembly (13) in position on plate (12) .
Show/hide table
Illustration 2 | g00501818 |
- Put pin (10) in plate assembly (11). Install washer (12) .
- Install sheave assembly (9) and washer (8) .
Show/hide table
Illustration 3 | g00501817 |
- Install plate assembly (7), sheave assembly (6) and washer (5) .
Show/hide table
Illustration 4 | g00501816 |
- Install plate assembly (2). Put spacer (4) in position and install two bolts (1) and two bolts (3) .
Show/hide table
Illustration 5 | g00501815 |
- Put lubricant in the bearings. Refer to Operation and Maintenance Manual, SEBU7109, "Sheave Block Bearings - Lubricate".
End By: Install the lower sheave block.
Caterpillar Information System:
3306C Engines for Caterpillar Built Machines Air Shutoff Solenoid
583R Pipelayer Power Train Power Train Oil Pump - Remove
583R Pipelayer Machine Systems Sheave Block (Lower) - Disassemble
769D Off-Highway Truck and 771D Quarry Truck Engine Crankcase Breather - Clean
Caterpillar Monitoring System Normal Mode
583R Pipelayer Power Train Power Train Oil Filter - Assemble
CB-534C Vibratory Compactor Fuel System - Prime
3406C Engines for Caterpillar Built Machines Governor
CB-534C Vibratory Compactor Engine Valve Lash - Check
789C Off-Highway Truck Hydraulic System Hoist System Troubleshooting
550 Wheel Harvester, 570 Wheel Harvester and 580 Wheel Harvester Hydraulic System Pendulum Arm Cylinder
784C, 785C and 785C HAA Off-Highway Truck/Tractors Hydraulic System Hoist System Troubleshooting
3406E On-Highway Engine Valve Mechanism Cover Base - Remove and Install
784C, 785C and 785C HAA Off-Highway Truck/Tractors Hydraulic System Control Valve (Hoist)
CB-534C Vibratory Compactor Rollover Protective Structure (ROPS) - Inspect
583R Pipelayer Machine Systems Hook Sheave Block (Upper) - Disassemble
769D Off-Highway Truck and 771D Quarry Truck Front Suspension Cylinder Rods - Lubricate
583R Pipelayer Power Train Recoil Spring - Install
583R Pipelayer Machine Systems Hook Sheave Block (Upper) - Assemble
583R Pipelayer Power Train Power Train Oil Pump - Install
IT14G Integrated Toolcarrier and 914G Wheel Loader Engine Supplement Engine and Pumps - Remove
IT14G Integrated Toolcarrier and 914G Wheel Loader Engine Supplement Engine and Pumps - Install
IT14G Integrated Toolcarrier and 914G Wheel Loader Standard Power Train Fixed Axle and Oscillating Axle
769D Off-Highway Truck and 771D Quarry Truck Fuel System Water Separator - Drain