Units Mode
Show/hide table
图 1 | g00301504 |
Caterpillar 监控系统 (1) 车速表/转速表模块。 (2) 主显示模块。 (3) 里程表单位。 (4) 速度读数区。 (5) 速度表单位。 (6) 显示区。 (7) 六位数显示区。 |
装置模式为模式 5。 单位模式用于在美制和英制测量单位之间进行显示转换。 当主显示模块进入单位模式时,六位数显示区 (7) 显示当前设置。 当模式被设置为美制单位制,显示器读取 "US" 读数。 当模式被设置为米制单位时,显示器读取 "SI" 读数。
当单位模式被设置为 US 单位且主显示模块处于里程表模式时,则主显示模块在显示区 (6) 显示 "英里(MILES)"。 速度表/转速表模块显示器显示 "MPH"。 当主显示模块被设置为米制单位时,显示区 (6) 显示 "KM"。 速度表/转速表模块显示器显示 "km/h"。
要切换单位,在断开维修输入时将清除输入接地。 当清除输入接地时单位连续转换。 打开两个输入装置将使主显示模块设置为当前显示的设置。
Caterpillar Information System:
VFS50 and VFS70 Versatile Flotation System Idler Bearings - Lubricate - Earlier Trailers
3054 Engine Rocker Shaft
784C and 785C Off-Highway Truck/Tractors Steering System Relief Valve (Cylinder Crossover) - Test and Adjust
784B and 785B Off-Highway Truck/Tractors Steering System Front Wheel - Align
Caterpillar Monitoring System Tattletale Mode
572R Pipelayer Tracks
784C and 785C Off-Highway Truck/Tractors Steering System Front Wheel Bearing - Adjust
VFS50 and VFS70 Versatile Flotation System Belts - Inspect/Adjust/Replace
VFS50 and VFS70 Versatile Flotation System Special Torques
IT14G Integrated Toolcarrier Starting Above 0°C (32°F)
IT14G Integrated Toolcarrier Walk-Around Inspection
VFS50 and VFS70 Versatile Flotation System Installation of Scale Group
416C, 426C, 428C, 436C and 438C Backhoe Loaders Axles, Differential and Brakes Drive and Steering Axle (Rear)
572R Pipelayer Transmission Oil Filter
VFS50 and VFS70 Versatile Flotation System Walk-Around Inspection
Caterpillar Monitoring System Setup Mode
583R Pipelayer Power Train Pivot Shaft
IT14G Integrated Toolcarrier Machine Operation Information
IT14G Integrated Toolcarrier Changing Speed and Direction
784C and 785C Off-Highway Truck/Tractors Steering System Visual Inspection
IT14G Integrated Toolcarrier Parking Brake
IT14G Integrated Toolcarrier Secondary Steering
Caterpillar Monitoring System Calibration Mode
Caterpillar Monitoring System General Information