Starting Above 0°C (32°F)
- Move the direction control lever or move the direction control switch (if equipped) into NEUTRAL.
- Move the control levers to the HOLD position.
- Turn the engine start switch to the ON position (1). Pause for three seconds for the secondary steering self-test (if equipped).
Show/hide table
Illustration 1 | g00412042 |
- Turn the engine start switch key to the START position (2) in order to start the engine. Release the key when the engine starts.
Show/hide table
NOTICE |
---|
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Turbocharger (if equipped) damage can result, if the engine is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient. |
Caterpillar Information System:
IT14G Integrated Toolcarrier Walk-Around Inspection
VFS50 and VFS70 Versatile Flotation System Installation of Scale Group
572R Pipelayer Power Train Oil Cooler
IT14G Integrated Toolcarrier Bucket Kickout and Positioner Control
583R Pipelayer Power Train Track Roller
3406E and 3456 Engines for Caterpillar Built Machines Compression Brake
IT14G Integrated Toolcarrier Hydraulic Lockout Control
784B and 785B Off-Highway Truck/Tractors Steering System Steering Accumulator - Test and Charge
784C and 785C Off-Highway Truck/Tractors Steering System Relief Valve (Steering) - Test and Adjust
VFS50 and VFS70 Versatile Flotation System Assembly of Hitch and Frame Version
IT14G Integrated Toolcarrier Ride Control - If Equipped
IT14G Integrated Toolcarrier Steering Column Tilt Control
VFS50 and VFS70 Versatile Flotation System Special Torques
VFS50 and VFS70 Versatile Flotation System Belts - Inspect/Adjust/Replace
784C and 785C Off-Highway Truck/Tractors Steering System Front Wheel Bearing - Adjust
572R Pipelayer Tracks
Caterpillar Monitoring System Tattletale Mode
784B and 785B Off-Highway Truck/Tractors Steering System Front Wheel - Align
784C and 785C Off-Highway Truck/Tractors Steering System Relief Valve (Cylinder Crossover) - Test and Adjust
3054 Engine Rocker Shaft
VFS50 and VFS70 Versatile Flotation System Idler Bearings - Lubricate - Earlier Trailers
Caterpillar Monitoring System Units Mode
416C, 426C, 428C, 436C and 438C Backhoe Loaders Axles, Differential and Brakes Drive and Steering Axle (Rear)
572R Pipelayer Transmission Oil Filter