Additional Remanufactured Water Pumps Available{1361}
Usage:
D342, D343, D346, D348, D349, D353, D379, D398, D399, 3306 And 3412 Engines
Remanufactured water pumps are now available for the above engines. These remanufactured water pumps will lower replacement costs. Remember the remanufactured water pumps have the same warranty as new water pumps.
Caterpillar Information System:
1983/10/31 Install Seal Correctly In Wheel Leaning Mechanism To Prevent Leakage{5224}
1983/10/31 Clean and Protect Split Master Links During Track Reconditioning{4176}
1983/10/24 Changes To Track Motor Guard Improve Protection{7163}
1983/10/24 FT1782 Turbocharger Test Stand Available{0651,1052}
1983/10/17 Valve Damage Can Be Caused By Short Intervals Of Engine Operation In Very Cold Temperatures{1105,1208}
1983/10/17 Remanufactured Fuel Pump And Governor Groups{1251,1264}
1983/10/17 New Pump Drive Gear And Shaft Have More Clearance{3101,3108}
1983/10/17 New Rod Ends And Supports Used In Hydraulic Control Groups{5452}
1983/10/17 Use Shims At Both Ends Of Housing Assembly To Prevent Oil Leakage From Power Control Group{5201}
1983/10/17 If The Cab Door Is Difficult To Open, Check Nylon Washer For Damage{7308}
1983/10/17 Changes To Torque Converter Inlet Relief Valve Increase Service Life{3167}
1983/10/17 Stronger Spider Assemblies Used In Fan Groups{1356}
1983/10/31 New Valve Lifter Assemblies Used In Valve Mechanism Groups{1209}
1983/10/31 Radiators With New Design Must Be Assembled With Thin Support Plate At The Top{1353}
1983/11/07 Correct Procedure To Start The Engine Will Help Prevent Damage To The Transmission{1424}
1983/11/07 Use 6V6070 Tool Group And New Adjustment Procedure For New Scroll Fuel System{0654,1264,1278}
1983/11/07 Explanation Of Engine High Idle RPM And Correct Adjustment Of Engine Setpoint{1264}
1983/11/14 Use Thread Lubricant When Wheels Are Installed{4202,4205}
1983/11/14 Use Oversize Insert To Rebuild Drive Plate Assembly In Track Motors{4351}
1983/11/14 Improved Oil Pan Drain Plug{1302}
1983/11/21 New Shafts Used In Fuel Injection Control Groups{1257}
1983/11/21 Sleeve Can Be Used For Reconditioning The Mounting Bore For The Fuel Pump Housing In The Cylinder Block{1201}
1983/11/21 Crankshaft Failures{1202,1230}
1983/11/21 Reuse Of Engine Bearings{1230,1219,1203}