New Rubber Lined Clamp Assembly Used In Fuel Injection Lines Groups{1252}
Usage:
3612 (9RC),
3616 (1PD) Engines
Description of Change: A new rubber lined clamp assembly is used in the fuel injection lines groups. Formerly, an all metal clamp was used. The new clamp assembly will help prevent fuel line wear.
New 4P-0707 Clamp Assembly. Rubber Grommet (1)
Adaptable To: The new 4P-0707 Clamp Assembly is a direct replacement for the 1W-3116 Clamp in the 7C-9428 (3612) and 1W-0925 (3616) Fuel Injection Lines Groups. The new clamp assemblies are effective with 3612 (9RC121) and 3616 (1PD67). The new clamp assembly can be used to replace the former clamp in the fuel injection lines groups on all earlier 3612 and 3616 Engines.
Caterpillar Information System:
1995/08/01 Torque Value Increased On Connector In Order To Prevent Loosening{1252}
1995/08/01 Changes To Heavy Fuel Flow Rate Requirements{1250}
1995/08/01 New Crankshaft Main Bearing Installation Procedure{1203}
1995/08/01 New Air Shut-Off Groups Used{1078}
1995/08/01 Change In Crankshaft Seal Wear Sleeve Installation Procedure{1160,1161}
1995/08/01 Improved Aftercooler Tube Assemblies Now Stainless Steel To Increase Corrosion Resistance{1063}
1995/08/01 New Adapters Used In Aftercooler Groups{1063}
1995/08/01 Turbocharger Cartridge Groups Available For Parts Service{1053,1052}
1995/08/01 New Turbocharger Bearing Clearance Specifications{1052,1053}
1995/08/01 New Air Cleaner And Silencer Has Increased Noise Attenuation{1051,1054}
1995/08/01 New Rain Shields And Automatic Draining Precleaner Cup Assembly Available{1051}
1995/08/01 New Piston Crown Assembly Used In Piston And Rod Group{1214}
1995/08/01 Liquid Level Gauge Available As Service Repair{1350,1354}
1995/08/01 New Water Temperature Regulator Used{1355}
1995/08/01 New High Temperature Resistant Seal Group And Seal Used In Water Pump Groups{1361}
1995/08/01 New Tube Assembly Used In Water Lines Groups{1380}
1995/08/01 Gasket To Be Replaced After Spark Plug Inspection{1555}
1995/08/01 New Jacket Water Inlet Regulator Requires Jacket Water Outlet Alarm Temperature Setting Change{7417,1355}
1995/08/01 New Programming Set Points For Electronic Modular Control Panel II (EMCP II){1404,7002,7451}
1995/08/01 Field Installation Procedure For Stator Thermocouples and RTDs{7498,4453}
1995/09/01 New Engine Water Pump Elbow and Seal Design{1361}
1995/09/01 New Thicker Exhaust Manifold Gasket Used{1059}
1995/09/01 New And Reconditioned Valve Projection Specifications{1105}
1995/09/01 Recommendations For Inspection And Replacement Of Rubber and Viscous Crankshaft Dampers{1205}