Air Starting Motor - Remove
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
 |
|
Shut off the air supply at the air reservoir. Drain the pressure air from the air starting system. Sudden release of pressure air can cause personal injury. |
- Turn OFF the air supply at the air reservoir. Ensure that the air pressure is drained from the starting air system.
- Disconnect harness assembly from air starting motor.
Show/hide table
Illustration 1 g06321280 - Attach a suitable lifting device to the air starting motor (2). The air starting motor weighs approximately
24 kg (53 lb) . - Remove three bolts (1) and remove the air starting motor (2).
Caterpillar Information System:
320D3 Excavators Engine Oil Sample - Obtain
320D3 Excavators Cooling System Coolant (ELC) - Change
C175 Tier 4 Final Engines for Caterpillar Built Machines Engine Oil Cooler - Disassemble
3500C IMO III Engines Solenoid Valve - Test - Engine
C7.1 (Mechanical) Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
320D3 and 323D3 Excavators Machine System Specifications Bucket Linkage - B1 Family
C7.1 (Mechanical) Engines for Caterpillar Built Machines Flywheel - Install
C7.1 (Mechanical) Engines for Caterpillar Built Machines Flywheel - Remove
C7.1 (Mechanical) Engines for Caterpillar Built Machines Crankcase Breather - Install
C7.1 (Mechanical) Engines for Caterpillar Built Machines Crankcase Breather - Remove
301.5,301.6,301.7,301.8,302 Mini Hydraulic Excavator Engine Supplement Engine - Remove and Install
C175-16 Petroleum Engine Sensor Signal (Analog, Active) - Test
797F Tier 4 Off-Highway Truck Engine Supplement Fuel Filter (Primary) and Fuel Filter Base - Remove and Install
Rework Procedure for Solar Charger Wires May be Reversed on Certain Generator Sets {1408, 7556} Rework Procedure for Solar Charger Wires May be Reversed on Certain Generator Sets {1408, 7556}
C175 Tier 4 Final Engines for Caterpillar Built Machines Engine Oil Cooler - Assemble
3516C IMO III Petroleum Engines Air Starting Motor - Install
New Oil Gauge is Now Used on Certain C9.3 Machine Engines {1326} New Oil Gauge is Now Used on Certain C9.3 Machine Engines {1326}
C7.1 (Mechanical) Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove
320D3 and 323D3 Excavators Machine System Specifications Main Hydraulic Pump and Mounting
320D3 and 323D3 Excavators Machine System Specifications Main Hydraulic Pump
Improved Switch Assembly for Quick Coupler Is Now Used on Certain 320, 320 GC, and 323 Excavators {1435} Improved Switch Assembly for Quick Coupler Is Now Used on Certain 320, 320 GC, and 323 Excavators {1435}
797F Tier 4 Off-Highway Truck Engine Supplement Fuel Pump (Electric) - Remove and Install - Clean Fuel Module
3516C IMO III Petroleum Engines Electronic Control Module (Engine) - Remove and Install - Primary ECM
3516C IMO III Petroleum Engines Electronic Control Module (Engine) - Remove and Install - Secondary ECM