Transmission Does Not Respond to Shift Selector
The shifter may not work properly if the transmission is not connected to the vehicle battery, the ignition switch is not connected or the J1939 Data Link is wiring is disconnected. The shift pad will display "--" instead of "NN" when the key start switch is turned to the ON position.
Check the following:
- Check for battery power to the Transmission ECU.
- Check for ignition power to the Transmission ECU.
- Check the J1939 Data Link wires and connectors.
- Verify that the correct serial number for the Transmission ECU has been programmed.
See the Testing and Adjusting, "Electrical Connector - Inspect" section of this manual for more information.
If the shifter only displays the right side digit, the serial number for the torque converter may not be programmed. Verify that the correct serial number for the torque converter has been programmed.
Caterpillar Information System:
CX38-P892 Well Servicing Transmission Transmission Does Not Automatically Shift Back Into Gear
CX38-P892 Well Servicing Transmission Transmission Does Not Automatically Shift Into Neutral
G3516 Petroleum Engines Cylinder Head - Remove
3516B Generator Set Engines with Dynamic Gas Blending Engine Monitoring System
3516B Generator Set Engines with Dynamic Gas Blending Electronic Control System Operation
3500B Generator Sets Voltage Regulators
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Aftercooler - Remove and Install - Aftercooler Housing with 24 bolts
New Heat Shields Are Now Used on Certain 3512 Locomotive Engines {1067, 7274} New Heat Shields Are Now Used on Certain 3512 Locomotive Engines {1067, 7274}
G3516 Petroleum Engines Rocker Shaft and Push Rod - Install
C175-16 Marine Engines Engine Governing - Adjust
C7.1 Marine Propulsion Engine Crankshaft
G3516 Petroleum Engines Rocker Shaft and Push Rod - Remove
CX38-P892 Well Servicing Transmission Replaced Relay or Solenoid Does Not Operate
CX38-P892 Well Servicing Transmission Diagnostic Code List
CX38-P892 Well Servicing Transmission Determining Diagnostic Codes
C9.3B Engines for Caterpillar Built Machines Alternator - Remove and Install
C9.3B Engines for Caterpillar Built Machines Air Compressor - Remove and Install
G3516 Petroleum Engines Cylinder Head - Install
C9.3B Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
CX38-P892 Well Servicing Transmission Safety Messages
C175 Tier 4 Final Engines for Off-Highway Trucks DEF Pressure Is Low
CX38-P892 Well Servicing Transmission Specifications
New Injector Wiring Harnesses Are Now Used on Certain C15 and C18 Engines {1290, 1408} New Injector Wiring Harnesses Are Now Used on Certain C15 and C18 Engines {1290, 1408}
C175 Generator Sets Engine Oil and Filter - Change