Rocker Shaft and Push Rod - Remove
Start By:
- Remove the valve cover and the spark plug. Refer to Disassembly and Assembly , "Valve Cover and Spark Plug - Removal and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500 , "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Remove two bolts (1) and remove rocker shaft (2) from the valve cover base.
Note: Place an identification mark on each pushrod to identify the proper location in the engine.
- Remove pushrods (3) from the valve lifters.
Show/hide table
Illustration 2 g06159926 - Remove valve bridges (4).
Show/hide table
Illustration 1 | g06159726 |
Caterpillar Information System:
CX38-P892 Well Servicing Transmission Engine Does Not Crank
CX38-P892 Well Servicing Transmission Event Code List
CX38-P892 Well Servicing Transmission Diagnostic Capabilities
CX38-P892 Well Servicing Transmission Connector Locations
CX38-P892 Well Servicing Transmission Service Tools
CX38-P892 Well Servicing Transmission General Information
CX38-P892 Well Servicing Transmission System Schematic
CX38-P892 Well Servicing Transmission Transmission - Calibrate
CX38-P892 Well Servicing Transmission Speed Sensor - Adjust
CX38-P892 Well Servicing Transmission Electronic Control Unit - Replace
CX38-P892 Well Servicing Transmission Electronic Control Unit - Configure
CX38-P892 Well Servicing Transmission Electronic Control Unit - Flash Program
C7.1 Marine Propulsion Engine Crankshaft
C175-16 Marine Engines Engine Governing - Adjust
G3516 Petroleum Engines Rocker Shaft and Push Rod - Install
New Heat Shields Are Now Used on Certain 3512 Locomotive Engines {1067, 7274} New Heat Shields Are Now Used on Certain 3512 Locomotive Engines {1067, 7274}
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Aftercooler - Remove and Install - Aftercooler Housing with 24 bolts
3500B Generator Sets Voltage Regulators
3516B Generator Set Engines with Dynamic Gas Blending Electronic Control System Operation
3516B Generator Set Engines with Dynamic Gas Blending Engine Monitoring System
G3516 Petroleum Engines Cylinder Head - Remove
CX38-P892 Well Servicing Transmission Transmission Does Not Automatically Shift Into Neutral
CX38-P892 Well Servicing Transmission Transmission Does Not Automatically Shift Back Into Gear
CX38-P892 Well Servicing Transmission Transmission Does Not Respond to Shift Selector