Turbocharger - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
\
- Inspect condition of all seals and gaskets. Replace if necessary.
Note: Attach suitable lifting device. Turbocharger weighs approximately
64.5 kg (142 lb) .Show/hide tableIllustration 1 g06118044 - Place turbocharger (5) in position and install bolts (6).
- Connect tube (8).
- Position bellows and tighten T-bolt clamp (7).
Show/hide table
Illustration 2 g06118094 - Position hose and tighten T-bolt clamps (4).
- Position bellows and install 4 bolts (4).
- Connect tube assembly (2)(3 tubes).
- Position bellows and install 6 bolts (1) to exhaust elbow.
Caterpillar Information System:
SCR Retrofit Aftertreatment Monitoring System
SCR Retrofit Aftertreatment Product Lifting
SCR Retrofit Aftertreatment Product Description
SR500 Generators Generator Installation
SCR Retrofit Aftertreatment Model View Illustrations
G3612 and G3616 Engines Fuel Shutoff Solenoid - Remove and Install
PM820, PM822, and PM825 Cold Planer Engine Supplement Battery - Remove and Install
SCR Retrofit Aftertreatment General Hazard Information
SCR Retrofit Aftertreatment Safety Messages
G3612 and G3616 Engines Cylinder Head - Install
Turbocharger Wastegate Hose On Certain C4.4 Engines {1052} Turbocharger Wastegate Hose On Certain C4.4 Engines {1052}
New Aftercooler Bonnets And Drain Line Are Now Used On Certain G3500 And CG170 Engines {1063, 1063} New Aftercooler Bonnets And Drain Line Are Now Used On Certain G3500 And CG170 Engines {1063, 1063}
349F and 352F Excavator Machine System Diagnostic Trouble Codes
PM-620 and PM-622 Cold Planer Engine Supplement Fuel Priming Pump and Primary Filter (Water Separator) - Remove and Install
A New Drive Bearing Is Now Used on Certain 3406E, C11, C13, C15, C16, and C18 Engines {1207} A New Drive Bearing Is Now Used on Certain 3406E, C11, C13, C15, C16, and C18 Engines {1207}
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Sensor Mounting
C13 Engines for Caterpillar Built Machines ECM Software - Install
349F and 352F Excavator Machine System Sensor Signal (PWM) - Test
349F and 352F Excavators Machine System Specifications Stick Cylinder
349F and 352F Excavator Machine System Sensor Supply - Test
349F and 352F Excavator Machine System Solenoid Valve - Test
349F and 352F Excavator Machine System Connector Contact Description
349F and 352F Excavator Machine System System Schematic
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Power Train Speed Sensor and Mounting