Battery - Remove and Install
- Turn the battery disconnect switch to the OFF position.
Show/hide table
Illustration 1 g06220823 - Open access panel (1).
Show/hide table
Illustration 2 g06220830 Show/hide table
Illustration 3 g06220833 - Disconnect cable assembly (4) from battery (2).
- Disconnect cable assemblies (5) and (6) from battery (3).
- Remove nut (7) and hold-down plate (8).
- Use two people to remove battery (2). The weight of battery (2) is approximately
52 kg (115 lb) . - Use two people to remove battery (3). The weight of battery (3) is approximately
52 kg (115 lb) .
- Install battery (2) and battery (3) in the reverse order of removal.
- Tighten nut (7) to a torque of
14 ± 3 N·m (124 ± 27 lb in) .
- Tighten nut (7) to a torque of
Caterpillar Information System:
SCR Retrofit Aftertreatment General Hazard Information
SCR Retrofit Aftertreatment Safety Messages
G3612 and G3616 Engines Cylinder Head - Install
Turbocharger Wastegate Hose On Certain C4.4 Engines {1052} Turbocharger Wastegate Hose On Certain C4.4 Engines {1052}
New Aftercooler Bonnets And Drain Line Are Now Used On Certain G3500 And CG170 Engines {1063, 1063} New Aftercooler Bonnets And Drain Line Are Now Used On Certain G3500 And CG170 Engines {1063, 1063}
PM820, PM822, and PM825 Cold Planer Rotor Coolant Level - Check
G3512 Generator Set Engine Turbocharger - Remove
PM820, PM822, and PM825 Cold Planer Rotor Bearing - Lubricate
Improved Procedure for the Installation of Swing Gear and Bearing Dust Seals on Certain Excavators {7063} Improved Procedure for the Installation of Swing Gear and Bearing Dust Seals on Certain Excavators {7063}
PM-620 and PM-622 Cold Planer Engine Supplement Muffler - Remove and Install
Fuel Injection Pump Solenoid on Certain C4.4 and C6.6 Engines {1251, 1403} Fuel Injection Pump Solenoid on Certain C4.4 and C6.6 Engines {1251, 1403}
G3512 Generator Set Engine Exhaust Manifold - Install
G3612 and G3616 Engines Fuel Shutoff Solenoid - Remove and Install
SCR Retrofit Aftertreatment Model View Illustrations
SR500 Generators Generator Installation
SCR Retrofit Aftertreatment Product Description
SCR Retrofit Aftertreatment Product Lifting
SCR Retrofit Aftertreatment Monitoring System
G3512 Generator Set Engine Turbocharger - Install
349F and 352F Excavator Machine System Diagnostic Trouble Codes
PM-620 and PM-622 Cold Planer Engine Supplement Fuel Priming Pump and Primary Filter (Water Separator) - Remove and Install
A New Drive Bearing Is Now Used on Certain 3406E, C11, C13, C15, C16, and C18 Engines {1207} A New Drive Bearing Is Now Used on Certain 3406E, C11, C13, C15, C16, and C18 Engines {1207}
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems Sensor Mounting
C13 Engines for Caterpillar Built Machines ECM Software - Install