High Fuel Rail Pressure Alarm May Malfunction on Certain Generator Sets {7610, 7620}
- Generator Set
- C175-16 GEN SET (S/N: WYB1-UP)
- C175-20 (S/N: BXR1-UP)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
The following issues have been found to occur due to high fuel rail pressure alarm malfunction:
- Fault alarm active on Electronic Module Control Panel (EMCP) after engine shutdown.
- Fault alarm may cause nuisance site alarms at engine shutdown depending on fault monitoring strategy. Alarm may require manual reset on EMCP to silence.
Note: Fault alarm has no effect on engine performance and will clear upon next start.
Solution
Caterpillar is aware of the problem and the permanent solution is under development. As an interim repair, replace the part numbers listed in Table 1 with the same part number.
Show/hide table
Part Number | Description |
---|---|
Engine Software | |
Engine Software | |
Engine Software | |
Engine Software | |
Engine Software | |
Engine Software | |
Engine Software | |
Engine Software | |
Engine Software | |
Engine Software | |
Engine Software |
Caterpillar Information System:
G3600 Engines Maintenance Interval Schedule
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Relief Valve (Charge) - Test - Conveyor
C9.3 Industrial Engine Selective Catalytic Reduction Warning System
XQP150 Rental Generator Set Generator Isolating for Maintenance
XQP150 Rental Generator Set Electrical System
PM620, PM622, PM820, PM822 and PM825 Cold Planer Propel Systems Travel Speed - Test
Beat In and Wear at the Clutch Plate Splines on Certain CX31 Transmissions {0374, 0599, 3030, 3050, 3064, 3160, 3190} Beat In and Wear at the Clutch Plate Splines on Certain CX31 Transmissions {0374, 0599, 3030, 3050, 3064, 3160, 3190}
C12.9 Marine Engines Rocker Arm and Shaft - Remove and Install
Proper Storage Procedures Are Available For Commercial Engines {1000} Proper Storage Procedures Are Available For Commercial Engines {1000}
Product Link For Generator Sets Features
C12.9 Marine Engines Fuel Lines - Remove and Install
C12.9 Marine Engines Electronic Unit Injector - Remove and Install
The Model Directory for Authorized Classic Machines has been Updated {1000, 7000} The Model Directory for Authorized Classic Machines has been Updated {1000, 7000}
PM620, PM622, PM820, PM822 and PM825 Cold Planer Propel Systems Machine Preparation for Troubleshooting
PM620, PM622, PM820, PM822 and PM825 Cold Planer Propel Systems Visual Inspection (Power Train)
PM620, PM622, PM820, PM822 and PM825 Cold Planer Propel Systems Propel System Troubleshooting
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Machine Preparation for Troubleshooting
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Visual Inspection (Auxiliary Hydraulic System)
PM620, PM622, PM820, PM822 and PM825 Cold Planer Machine System Auxiliary Hydraulic System Troubleshooting
C9.3 Marine Auxiliary Engines Maintenance Interval Schedule - Marine Generator Set
® Grade & Slope for Cold Planers Grade Control Guidance Screen
3516C Generator Set Engines Turbocharger - Install
C18 Generator Set Engines Water Pump - Disassemble
C18 Generator Set Engines Water Pump - Assemble