Electronic Unit Injector - Remove
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 5F-4764 | Pry Bar | 1 |
Start By:
- Remove the rocker shaft assembly.
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (2) from electronic unit injector (5).
- Remove bolt (1) and electronic unit injector clamp (3).
- Remove plug (4) from the cylinder head.
- Place an identification mark on the electronic unit injector for installation purposes. Each electronic unit injector must be reinstalled in the original location in the cylinder head.
Show/hide table
Illustration 2 g01130569 - Use Tooling (A) to remove electronic unit injector (5) from the cylinder head.
- Remove O-ring seal (6) and O-ring seal (7) from the electronic unit injector.
Show/hide table
| |
| Illustration 1 | g01130566 |
Caterpillar Information System:
XQC1200 and XQC1600 Power Modules Water Pump - Assemble
3516C and C175-16 Engines Selective Catalytic Reduction Sensor (Data Link Type) - Test
G3500 Engines Engine Air Filter Service Indicator - Inspect
XQC1200 and XQC1600 Power Modules Water Pump - Disassemble
G3500 Engines Fluid Recommendations
G3500 Engines Refill Capacities
320D and 323D Excavators Machine System Specifications Auxiliary Hydraulic Lines
2014/07/25 Capturing Engine Stop Messages and Idle Information on All Caterpillar Products Equipped with Product Link 522 {7606}
G3500 Engines Welding on Engines with Electronic Controls
C8.7 Marine Engines Engine Oil Pressure - Test
Inspection and Installation Procedure for C175 Exhaust Bellows {1059, 1061} Inspection and Installation Procedure for C175 Exhaust Bellows {1059, 1061}
C8.7 Marine Engines Vibration Damper - Check
Bench Test Procedure for Hydraulic Piston Pumps{0599, 5070, 5070} Bench Test Procedure for Hydraulic Piston Pumps{0599, 5070, 5070}
XQC1200 and XQC1600 Power Modules Electronic Unit Injector - Install
XQC1200 and XQC1600 Power Modules Cylinder Head - Remove
XQC1200 and XQC1600 Power Modules Cylinder Head - Install
3516C and C175-16 Engines Selective Catalytic Reduction SCR Catalyst Temperature Sensor - Test
XQC1200 and XQC1600 Power Modules Inlet and Exhaust Valve Springs - Remove and Install
XQC1200 and XQC1600 Power Modules Inlet and Exhaust Valves - Remove and Install
3516C and C175-16 Engines Selective Catalytic Reduction Clean Emissions Module Has High Oxygen Level
XQC1200 and XQC1600 Power Modules Inlet and Exhaust Valve Guides - Remove and Install
C18 Engine Maintenance Interval Schedule
XQC1200 and XQC1600 Power Modules Inlet and Exhaust Valve Seat Inserts - Remove and Install
C18 Marine Engine Maintenance Interval Schedule