Air Compressor Drive Gear Holding Tool Available{0700,1803}
Usage:
C-10 (2PN, 3CS, 8YS);
C-12 (1YN, 2KS, 9NS),
3406E (1LW, 1MM, 2WS, 5DS, 5EK, 6TS, 9WR),
3456 (3LW) Truck Engines
A 132-5451 Air Compressor Gear Holder Tool is now available for these truck engines. This tool is used to keep the air compressor shaft from turning while removing or installing the air compressor drive gear retaining nut. The tool reduces possibility of damage during overhaul and makes removing or installing air compressor drive gear retaining nut much simpler and faster.
132-5451 Air Compressor Gear Holder.
Caterpillar Information System:
1999/02/01 Installation Procedure For Hydraulic Electronic Unit Injector (HEUI) Oil Pump High Pressure Oil Line{1714}
1999/01/01 Use 144-0235 Belt Tension Gauge To Check Belt Tension{7461,1357}
1999/01/01 New Two-Piece Spool And Diaphragm For BrakeSaver Control Valve Now Used{1155}
1999/01/01 Caterpillar Driver Information Display (Cat ID) Version 2.0 Release For On-Highway Truck{1920}
1999/01/01 On-Highway Heavy Duty 1999 Model Year Truck Software Release{1920}
1999/01/01 On-Highway Heavy Duty 1999 Model Year Truck Electronic System{1900}
1999/01/01 Camshaft And Follower Lubricant Recommended During Rebuild And Assembly Of Engines{1210,1211}
1999/01/01 Electronic Technician (ET) Version 2.3 Update{1920}
1999/01/01 Electronic Controller Analyzer Programmer (ECAP) Truck SPM Version 2.3 Update{1920}
1998/12/01 Use 145-9342 Filter Crusher To Reduce Waste And Collect Oil{5720}
1998/12/01 Use 9U-5968 Hydrostatic Filter Group To Filter Contaminated Oil{5050,3200,3218}
1998/12/01 Use 139-2610 Or 139-2611 (CE Certified) Refrigerant Identification Instrument To Determine Refrigerant Content{1809}
1999/03/01 Optional 4-Pin Coolant Level Sensor {1395}
1999/03/01 70-Pin Breakout "T" Harness For The ADEM 2000 Truck Engine ECM {1901}
1999/03/01 Troubleshooting Guide Corrections {0350}
1999/03/01 Use 145-5247 And 147-2675 Wear Sleeve Installer To Install Crankshaft Wear Sleeves {1202}
1999/03/01 Create And Save The ECM Customer Parameters List As A Back-Up {1901}
1999/03/01 Installing 1999 ADEM 2000 HD Engine Into Earlier ADEM II HD Engine Chassis {1901,1923}
1999/03/01 New Turbocharger And Software Used {1052}
1999/03/01 New O-Ring Seals For Unit Injector Sleeves {1125}
1999/03/01 Atmospheric Pressure Sensor Design Improvements {1901,1923}
1999/04/01 New Caterpillar High Efficiency Fuel Filters With STAY CLEAN VALVES® Replace All Standard Fuel Filters In February Of 1999{1261}
1999/04/01 Hydraulic Electronic Unit Injector (HEUI) Pump Service Tips{1714}
1999/04/01 Exhaust Brakes May Need To Be Modified Or Replaced{1093}