C27 and C32 Engines for Caterpillar Built Machines Caterpillar


Vibration Damper and Pulley - Remove and Install

Usage:

854K 221

拆卸步骤

  1. 如有必要,从发动机上拆下传动带。 参考操作和保养手册, "皮带 - 检查/调整/更换"。



    图 1g03687235

  1. 拆下螺栓 (2) 、适配器 (3) 和皮带轮 (1) 。



    图 2g03687259

  1. 将适当的起吊设备连接到减振器 (4) 上。 减振器 (4) 的重量约为 35 kg (77 lb)。

  1. 拆下螺栓 (6) ,然后将减振器 (4) 和适配器 (5) 滑出。

安装步骤

  1. 按与拆卸相反的顺序安装减振器 (4) 。

Caterpillar Information System:

C27 and C32 Engines for Caterpillar Built Machines Exhaust Manifold - Remove and Install
XQC1200 and XQC1600 Power Modules Water Temperature Regulators - Remove and Install
Installation of the 459-5764 Engine Electronics {1901, 1920} Installation of the 459-5764 Engine Electronics {1901, 1920}
C3.4B Engines for Caterpillar Built Machines Electric Starting Motor - Remove and Install
C3.4B Engines for Caterpillar Built Machines Alternator - Install
C3.4B Engines for Caterpillar Built Machines Alternator - Remove
C3.4B Engines for Caterpillar Built Machines Fan Drive - Remove and Install
C3.4B Engines for Caterpillar Built Machines Fan - Remove and Install
C3.4B Engines for Caterpillar Built Machines Idler Pulley - Remove and Install
C3.4B Engines for Caterpillar Built Machines Alternator Belt - Remove and Install
C3.4B Engines for Caterpillar Built Machines Glow Plugs - Remove and Install
C3.4B Engines for Caterpillar Built Machines Inlet Manifold Pressure Sensor - Remove and Install
C175-16 PETROLEUM ENGINES Fuel Control Valve - Remove and Install - Primary
XQC1200 and XQC1600 Power Modules Water Pump - Remove and Install
2014/06/20 A Shorter Plug Is Required on the Water Pump Group of Certain C-9 Engines {1361, 7553}
C8.7 Marine Engine Oil Cooler Core - Check/Clean/Test - Gear Oil Cooler - If Equipped
XQC1200 and XQC1600 Power Modules Water Temperature Regulators - Remove and Install - Auxiliary Water System
C175-16 PETROLEUM ENGINES Fuel Pump (High Pressure) - Remove and Install
C8.7 Marine Engine Belt - Inspect
2014/06/13 New Engine Software Is Used on Certain C175 Electric Power Generation (EPG) Engines {1901, 1920}
2014/06/13 Additional Diesel Particulate Filter (DPF) Ash Service Cleaning Interval Information Is Now Used On Certain Tier 4 Interim and Tier 4 Final C7.1 - C18 Engines {108F}
797 Off-Highway Truck Manual Lowering (Powered Stairway) - Test - If Equipped
421-1011 Valve Recession Tool Group used on G3500 C, E, ; H Engines{0374, 0599, 0701, 0703, 1100} 421-1011 Valve Recession Tool Group used on G3500 C, E, & H Engines{0374, 0599, 0701, 0703, 1100}
797 Off-Highway Truck Hydraulic System Hoist System - Oil Makeup - If Equipped
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.