Exhaust Elbow - Remove and Install
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | - | Loctite C5-A Copper Anti-Seize Lubricant | - |
Start By:
- Remove turbochargers.
- Remove insulation (1).
Show/hide table
Illustration 2 g03686324 - Remove bolts (4). Using two people, remove bolts (2) and remove exhaust pipe (3). The weight of exhaust pipe (3) is approximately
39 kg (86 lb) . - Attach a suitable lifting device to exhaust elbow (5). The weight of exhaust elbow (5) is approximately
52 kg (115 lb) . Remove bolts (6) and remove exhaust elbow (5).
Show/hide table
Illustration 1 | g03686323 |
- Install exhaust elbow (5) in the reverse order of removal.
- Apply Tooling (A) to bolts (2) and (4).
- Tighten bolts (6) to a torque of
120 ± 20 N·m (89 ± 15 lb ft) .
Caterpillar Information System:
455-1194 Top End Overhaul Foundational Kit for C18 Marine Engines{1000} 455-1194 Top End Overhaul Foundational Kit for C18 Marine Engines{1000}
C27 and C32 Generator Set Engines Electronic Control Module - Remove and Install
C27 and C32 Generator Set Engines Turbocharger Outlet Pressure Sensor - Remove and Install
C27 and C32 Generator Set Engines Inlet Air Temperature Sensor - Remove and Install
C27 and C32 Generator Set Engines Fuel Temperature Sensor - Remove and Install
C27 and C32 Generator Set Engines Fuel Pressure Sensor - Remove and Install
C27 and C32 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
C27 and C32 Generator Set Engines Coolant Temperature Sensor - Remove and Install
C27 and C32 Generator Set Engines Crankshaft Position Sensor - Remove and Install
C27 and C32 Generator Set Engines Camshaft Position Sensor - Remove and Install
C4.4 Engines for Caterpillar Built Machines Camshaft Gear - Remove and Install
C27 and C32 Generator Set Engines Atmospheric Pressure Sensor - Remove and Install
Procedure for Seismic Anchor Installation of Multi Module Systems{4480} Procedure for Seismic Anchor Installation of Multi Module Systems{4480}
Installation Guide for the Tire Monitoring System on Cat® and Non-Cat Equipment {4203, 7490} Installation Guide for the Tire Monitoring System on Cat® and Non-Cat Equipment {4203, 7490}
C3.4B Engines for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
C3.4B Engines for Caterpillar Built Machines Flow Control Valve - Remove and Install
C3.4B Engines for Caterpillar Built Machines Fuel Filter Base - Remove and Install
C3.4B Engines for Caterpillar Built Machines Water Separator and Fuel Filter (Primary) - Remove and Install
C3.4B Engines for Caterpillar Built Machines Fuel Manifold (Rail) - Remove and Install
C3.4B Engines for Caterpillar Built Machines Fuel Injection Lines - Remove
C3.4B Engines for Caterpillar Built Machines Fuel Injection Lines - Install
C3.4B Engines for Caterpillar Built Machines Exhaust Cooler (NRS) - Remove and Install
C3.4B Engines for Caterpillar Built Machines Throttle Valve (Intake Air) - Remove and Install - Rear Facing Inlet Elbow
C3.4B Engines for Caterpillar Built Machines Throttle Valve (Intake Air) - Remove and Install - Side Facing Inlet Elbow