Fuel Filter (Secondary) and Fuel Filter Base - Remove and Install
拆卸步骤
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 187-2718 | 滤清器扳手 | 1 |
Show/hide table
 |
不遵守下列步骤将有可能造成人身伤亡。 渗漏或溅溢到热表面或电气部件上的燃油会引起失火。 要擦净所有泄漏或喷溅的燃油。 对燃油系统进行工作时不要吸烟。 更换燃油滤清器时，要将断路开关转到“断开”位置或断开蓄电池。 |
- 将燃油供应转到断开位置。
- 拆下螺栓 (1) 和盖 (2) 。
Show/hide table
 | |
| 图 1 | g03623206 |
- 拆下燃油滤清器 (7) 。 断开线束组件 (4) 和软管组件 (6) 。
Show/hide table
 | |
| 图 2 | g03623639 |
- 拆下螺栓 (3) 和滤清器底座 (5) 。
- 拆下燃油温度传感器 (8) 和燃油压力传感器 (9) 。
Show/hide table
 | |
| 图 3 | g03623736 |
安装步骤
- 按与拆卸相反的顺序安装燃油滤清器底座 (5) 。
- 将燃油温度传感器 (8) 上紧到 20 ± 3 N·m (177 ± 27 lb in) 的扭矩。
- 拧紧燃油压力传感器 (9) 至扭矩为 10 ± 2 N·m (89 ± 18 lb in)。
- 利用要密封的润滑剂润滑燃油滤清器 (7) 的密封件和孔。 拧紧燃油滤清器 (7) 至扭矩为 35 ± 3 N·m (26 ± 2 lb ft)。
Caterpillar Information System:
C3.4B Engines Sensor Signal (Analog, Passive) - Test
C3.4B Engines Sensor Signal (Analog, Active) - Test
C4.4 Marine Generator Set Engine Crankcase Breather - Replace
C4.4 Marine Generator Set Oil Filter Differential Pressure Problem
C4.4 Marine Generator Set Fuel Filter Is Restricted - Secondary Fuel Filter
C3.4B Engines Sensor Signal (Analog, Active) - Test - Exhaust Gas Pressure Sensor
C4.4 Marine Generator Set Fuel Filter Is Restricted - Primary Fuel Filter
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies AP Control Board
390F Excavator C18 Engine Supplement Fuel Filter and Water Separator Base - Remove and Install
2014/03/07 An Improved Oil Filter Housing Is Used for Certain C175 Commercial Engines {1306}
390F Excavator C18 Engine Supplement Air Control Valve - Remove and Install
390F Excavator C18 Engine Supplement Nitrogen Oxide Sensor - Remove and Install - Inlet
3512C Marine Auxiliary Generator Set Engines with Dynamic Gas Blending System Overview
G3304B and G3306B Engines Overhaul (Major)
C4.4 Engines for Caterpillar Built Machines Gear Group (Front) - Time
2014/03/10 Improved Torque Converter Housings Are Now Used on Certain On-Highway Transmissions, Petroleum Transmissions, and Petroleum Power Train Packages {3105}
390F Excavator Engine Oil Filter Base - Remove and Install
C3.4B Engines Solenoid Valve - Test
390F Excavator Engine Oil Filter Base - Disassemble
390F Excavator Engine Oil Filter Base - Assemble
390F Excavator C18 Engine Supplement Engine Oil Cooler - Remove and Install
390F Excavator Engine Electronic Control - Remove and Install
UPS 750 Uninterruptible Power Supply Specifications
390F Excavator Air Cleaner - Remove and Install