Fuel Manifold (ARD) - Remove and Install
拆卸步骤
- 断开线束组件 (2) 。 断开软管组件 (1) 和 (3) 。
Show/hide table
图 1 | g03607940 |
- 拆下螺栓 (5) ,然后拆下燃油歧管 (4) 。
- 拆下适配器组件 (6) 。 拆下传感器 (7) 和 O 形密封圈。
Show/hide table
图 2 | g02824099 |
- 拆下电磁阀 (8) 。
- 拆下盖 (10) ,然后拆下接头组件 (9) 。
- 拆下螺母 (15) 、垫圈 (14) 和电磁阀 (13) 。
Show/hide table
图 3 | g02824097 |
- 拆下芯组件 (12) ,然后拆下 O 形密封圈 (11) 。
安装步骤
- 按与拆卸相反的顺序安装燃油歧管 (4) 。
- 将螺母 (15) 拧紧至扭矩为 20 ± 2.5 N·m (177 ± 22 lb in)。
- 拧紧电磁阀 (8) 至扭矩为 50 ± 5 N·m (37 ± 4 lb ft)。
- 拧紧接头组件 (9) 至扭矩为 30 ± 3 N·m (22 ± 2 lb ft)。
- 将盖 (10) 拧紧至扭矩为 7.0 ± 2.5 N·m (62 ± 22 lb in)。
- 将传感器 (7) 拧紧至扭矩为 30 ± 3 N·m (22 ± 2 lb ft)。
- 将适配器组件 (6) 拧紧至扭矩为 17 ± 1.5 N·m (150 ± 13 lb in)。
Caterpillar Information System:
374F and 390F Excavators and 390F MHPU Mobile Hydraulic Power Unit Boom Hydraulic System - Health Check
390F Excavator C18 Engine Supplement Catalyst (SCR) - Remove and Install
DE Series Generator Sets With Cat C3.3 Engine Starting Motor - Inspect
DE Series Generator Sets With Cat C3.3 Engine Fuel System Secondary Filter - Replace
DE Series Generator Sets With Cat C3.3 Engine Fuel System Primary Filter/Water Separator - Drain
DE Series Generator Sets With Cat C3.3 Engine Fuel System Primary Filter (Water Separator) Element - Replace
DE Series Generator Set with Cat C1.1, C1.5, and C2.2 Engines Hoses and Clamps - Inspect/Replace
DE Series Generator Sets With Cat C3.3 Engine Fuel System - Prime
DE Series Generator Set with Cat C1.1, C1.5, and C2.2 Engines Fuel Tank Water and Sediment - Drain
DE Series Generator Sets With Cat C3.3 Engine Engine Oil and Filter - Change
390F Excavator C18 Engine Supplement Diesel Particulate Filter - Remove and Install
DE Series Generator Sets With Cat C3.3 Engine Engine Oil Level - Check
390F Excavator C18 Engine Supplement Temperature Sensor (Catalyst Inlet) - Remove and Install
349F and 352F Excavators Machine System Specifications Fasteners
349F and 352F Excavators Machine System Specifications Pilot Lines
C4.4 Marine Generator Set Speed/Timing - Test
XQ125 Generator Set Fan Clearance - Check
C3.4B Engines Glow Plug Starting Aid - Test
390F Excavator C18 Engine Supplement Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
349F and 352F Excavators Machine System Specifications Track Adjuster
2014/02/26 A New Sea Water Plug and Zinc Rod Are Used On Certain C32 Marine Engines {1379}
C27 and C32 Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
C175-16 Petroleum Generator Set Engines Centrifugal Oil Filter - Clean
The Hydraulic Tank Baffle is Failing on Certain Off-Highway Trucks{5056} The Hydraulic Tank Baffle is Failing on Certain Off-Highway Trucks{5056}