Flywheel - Remove and Install
拆卸步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | FT2712     | 导向双头螺栓     | 2     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 拆下两个螺栓 (1) 。 安装工具 (A) 。
Show/hide table
图 1 | g03521506 |
- 卸下将飞轮固定在曲轴上的其余螺栓 (1) 。 由两个人一起拆下飞轮 (2) 。 飞轮 (2) 的重量约为 35 kg (77 lb)。
- 必要时,利用手锤和冲头将齿圈 (3) 从飞轮上拆下。
Show/hide table
图 2 | g01953204 |
典型示例 |
安装步骤
- 按与拆卸相反的顺序安装飞轮 (2) 。
- 用清洁、未经使用的发动机机油润滑螺栓 (1) 并将螺栓 (1) 拧紧至扭矩为 272 ± 27 N·m (201 ± 20 lb ft)。
Caterpillar Information System:
CX31-P600 Petroleum Transmission Transmission Planetary Troubleshooting
C15 and C18 On-Highway Engines Water Temperature Regulator Housing - Remove and Install
CX31-P600 Petroleum Transmission Torque Converter Troubleshooting
CX31-P600 Petroleum Transmission Visual Inspection
C280-16 Engine Alternator - Replace
2014/02/20 New Anti Drift Valves are Now Used on Certain 345D and 349D Excavators {5059}
C15 and C18 On-Highway Engines Engine Oil Pump - Remove and Install
Reuse and Salvage for Engine Dampers {1202, 1205} Reuse and Salvage for Engine Dampers {1202, 1205}
2013/11/13 A New Alternator and Alternator Bracket Have Been Introduced on Certain C4.4 and C6.6 Engines {1405, 1425}
G3500H Generator Set Engine Electric Starting System
G3500H Generator Set Engine Pistons, Rings and Connecting Rods
G3500H Generator Set Engine Cooling System
CX31-P600 Petroleum Transmission Hydraulic Oil Contamination - Test
C280 Marine Engines Battery
C15 and C18 On-Highway Engines Flywheel Housing - Remove and Install - Power Take Off equipped
C15 and C18 On-Highway Engines Power Take-Off Drive Group - Assemble
C15 and C18 On-Highway Engines Crankshaft Front Seal - Remove and Install
Exhaust Leaks May Cause Failures of the 195-2431 Detonation Sensor Groups on Certain G3500 Engines{1408, 7400} Exhaust Leaks May Cause Failures of the 195-2431 Detonation Sensor Groups on Certain G3500 Engines{1408, 7400}
C15 and C18 On-Highway Engines Rocker Arm and Shaft - Remove and Install
C15 and C18 On-Highway Engines Cylinder Head - Remove and Install
C280-16 Engine Exhaust Manifold Shield - Remove and Install
3516C Marine Engine Catalyst (SCR) - Replace
Procedure for Installing the 450-6188 Solenoid Valve Gp and 450-3897 Wiring Harness on G3500 Petroleum Engines{5479} Procedure for Installing the 450-6188 Solenoid Valve Gp and 450-3897 Wiring Harness on G3500 Petroleum Engines{5479}
2013/12/19 New Software Is Used on Certain C32 Marine Engines {1901, 1920}