Hydraulic Starting Motor - Remove and Install
Removal Procedure
- Remove bolts (1) and hydraulic starting motor (2). Hydraulic starting motor (2) weighs approximately 25 kg (55 lb).
Show/hide table
Illustration 1 | g03415944 |
- Repeat Step 1 for the remaining hydraulic starting motor.
Installation Procedure
- Install hydraulic starting motor (2) in the reverse order of removal.
Caterpillar Information System:
C4.4 Industrial Engine Battery Disconnect Switch
2014/03/14 A New Wiring Harness Is Used in the Dosing Cabinets of Certain 3516C and C175-16 Engines {108H, 1091, 1408}
C15 Petroleum Engines Maintenance Interval Schedule
794 AC Off-Highway Truck Coolant Pressure Cap - Clean/Replace
C175-16 Engine for 795F Series AC Off-Highway Trucks Fuel Priming Pump
C7.1 Industrial Engine Battery Disconnect Switch - If Equipped
399-9725 SCR Catalyst Lifting Device{0629, 0632, 1075, 108H} 399-9725 SCR Catalyst Lifting Device{0629, 0632, 1075, 108H}
3512E Petroleum Engines Hydraulic Starting Motor - Remove and Install
3512C Petroleum Engines Catalyst - Remove and Install
3512E Petroleum Engines Flywheel Housing - Remove
3512C Petroleum Engines Vibration Damper - Remove and Install
3512E Petroleum Engines Engine Oil Pump - Remove and Install
C7.1 Engines Diesel Oxidation Catalyst Has Incorrect Inlet Temperature
C7.1 Engines Camshaft Position Sensor - Remove and Install
C4.4 Engines Diesel Oxidation Catalyst Has Low Conversion Efficiency
2013/08/06 New Engine Oil Filter for C3.4B Engines {1308}
2013/08/15 New Software For Cat® ET Can Now Be Used For All Caterpillar Products {0785, 7606}
3500 Engines Engine Oil Cooler - Disassemble
3500 Engines Engine Oil Cooler - Assemble
2013/09/16 New Wiring Harness Film Is Used for the Pre-lubrication Pump on Certain G3500 Engines {1319, 1408}
C7.1 Industrial Engine Diesel Exhaust Fluid - Fill
2013/09/20 A New and Improved Switch and Contactor Are Used for the Jacket Water Heater Control on Certain 3512C Engines {1383, 1408, 1408}
C15 and C18 Engines for China On-Highway Phase IV Diagnostic Capabilities
349F and 352F Excavators Leaving the Machine