New Engine Oil Filter for C3.4B Engines {1308}
- Industrial Engine:
- C3.4B (S/N: CJG1-1722)
Description of Change: A new engine oil filter and O-ring have been introduced.
Adaptable To: New 441-6852 Filter replaces 374-0619 Filter .
For the correct procedure to install the new engine oil filter and O-ring follow step 1 through to step 3.
- Clean sealing surface (1) .
Show/hide table
Illustration 1 | g03412545 |
Typical example |
- Apply clean engine oil to the new O-ring seal (2) on the new engine oil filter.
- Install the engine oil filter, spin on the oil filter until the O-ring seal contacts the oil filter base. Then, rotate the oil filter ? of a full turn, by hand only.
Show/hide table
NOTICE |
---|
Do not fill the oil filters with oil before installing them. This oil would not be filtered and could be contaminated. Contaminated oil can cause accelerated wear to engine components. |
Caterpillar Information System:
C4.4 Engines Diesel Oxidation Catalyst Has Low Conversion Efficiency
C7.1 Engines Camshaft Position Sensor - Remove and Install
C7.1 Engines Diesel Oxidation Catalyst Has Incorrect Inlet Temperature
3516C Petroleum Engines Hydraulic Starting Motor - Remove and Install
C4.4 Industrial Engine Battery Disconnect Switch
2014/03/14 A New Wiring Harness Is Used in the Dosing Cabinets of Certain 3516C and C175-16 Engines {108H, 1091, 1408}
C15 Petroleum Engines Maintenance Interval Schedule
794 AC Off-Highway Truck Coolant Pressure Cap - Clean/Replace
C175-16 Engine for 795F Series AC Off-Highway Trucks Fuel Priming Pump
C7.1 Industrial Engine Battery Disconnect Switch - If Equipped
399-9725 SCR Catalyst Lifting Device{0629, 0632, 1075, 108H} 399-9725 SCR Catalyst Lifting Device{0629, 0632, 1075, 108H}
3512E Petroleum Engines Hydraulic Starting Motor - Remove and Install
2013/08/15 New Software For Cat® ET Can Now Be Used For All Caterpillar Products {0785, 7606}
3500 Engines Engine Oil Cooler - Disassemble
3500 Engines Engine Oil Cooler - Assemble
2013/09/16 New Wiring Harness Film Is Used for the Pre-lubrication Pump on Certain G3500 Engines {1319, 1408}
C7.1 Industrial Engine Diesel Exhaust Fluid - Fill
2013/09/20 A New and Improved Switch and Contactor Are Used for the Jacket Water Heater Control on Certain 3512C Engines {1383, 1408, 1408}
C15 and C18 Engines for China On-Highway Phase IV Diagnostic Capabilities
349F and 352F Excavators Leaving the Machine
C7.1 Industrial Engine Injector (Diesel Exhaust Fluid) - Replace
C13 Generator Set Engine Exhaust Manifold - Remove and Install
3500 Engines Turbocharger - Remove
3500 Engines Turbocharger - Install