A New Wiring Harness Is Used in the Dosing Cabinets of Certain 3516C and C175-16 Engines {108H, 1091, 1408}
- Engine:
- 3516C (S/N: SKC1-UP; SCJ1-UP; SCK1-UP; SFK1-UP)
- C175-16 (S/N: WYC1-UP)
Description of Change: The new wiring harness inside of the dosing cabinet has been modified to remove the CAN datalink terminating resistor to prevent unwanted fault codes.
Adaptable To: The 449-3779 Control Harness As replaces the existing harness which contains the 134-2540 Resistor As. The new harness assembly is adaptable back to first production on the engines listed above.
The change is effective with the serial numbers listed in Table 1
Show/hide table
Sales Model     | Effective Serial Numbers     |
---|---|
3516C     | S/N:SCJ00115-UP S/N:SCK00124-UP S/N:SFK00107-UP S/N:SKC00110-UP     |
C175-16     | S/N:WYC01000-UP     |
Caterpillar Information System:
C15 Petroleum Engines Maintenance Interval Schedule
794 AC Off-Highway Truck Coolant Pressure Cap - Clean/Replace
C175-16 Engine for 795F Series AC Off-Highway Trucks Fuel Priming Pump
C7.1 Industrial Engine Battery Disconnect Switch - If Equipped
399-9725 SCR Catalyst Lifting Device{0629, 0632, 1075, 108H} 399-9725 SCR Catalyst Lifting Device{0629, 0632, 1075, 108H}
3512E Petroleum Engines Hydraulic Starting Motor - Remove and Install
3512C Petroleum Engines Catalyst - Remove and Install
3512E Petroleum Engines Flywheel Housing - Remove
3512C Petroleum Engines Vibration Damper - Remove and Install
3512E Petroleum Engines Engine Oil Pump - Remove and Install
3512E Petroleum Engines Engine Oil Cooler - Assemble
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies DC Bus Capacitor - Remove and Install
C4.4 Industrial Engine Battery Disconnect Switch
3516C Petroleum Engines Hydraulic Starting Motor - Remove and Install
C7.1 Engines Diesel Oxidation Catalyst Has Incorrect Inlet Temperature
C7.1 Engines Camshaft Position Sensor - Remove and Install
C4.4 Engines Diesel Oxidation Catalyst Has Low Conversion Efficiency
2013/08/06 New Engine Oil Filter for C3.4B Engines {1308}
2013/08/15 New Software For Cat® ET Can Now Be Used For All Caterpillar Products {0785, 7606}
3500 Engines Engine Oil Cooler - Disassemble
3500 Engines Engine Oil Cooler - Assemble
2013/09/16 New Wiring Harness Film Is Used for the Pre-lubrication Pump on Certain G3500 Engines {1319, 1408}
C7.1 Industrial Engine Diesel Exhaust Fluid - Fill
2013/09/20 A New and Improved Switch and Contactor Are Used for the Jacket Water Heater Control on Certain 3512C Engines {1383, 1408, 1408}