Later Pre-Chamber Cylinder Heads On Early 3304 Engines Without Drilled Rocker Stands Are Used {1100}
- Engine:
- 3300
- Machine Engines:
- 3304
- 3300
Show/hide table
Illustration 1 | g03288096 |
View of non-drilled rocker stand and drilled head with uncovered oil supply passage |
On early pre-chamber cylinder heads that are used on 3304 engines, passages were not drilled into the cylinder head to supply engine oil to the valve train. The part number is 2P-6484 Cylinder Head Gp. This remanufactured head casting is no longer available.
A new rocker stand and rocker shaft must be used with 0R-2674 and 0R-2675 cylinder heads with drilled rocker lube holes. A 7N-8015 Bracket and a 8N-3312 Rocker Arm Shaft must be ordered along with the cylinder head. The combination of parts allows the engine valve train components to receive adequate lubrication.
Caterpillar Information System:
2012/10/30 A New Pressure Relief Valve for the Fuel Rail Group Is Used in Certain C9.3 Industrial Engines {1288}
C1.5 and C2.2 Industrial Engines Customer Specified Parameters Worksheet
C175-16 Generator Set Engine Engine Oil Pan - Remove and Install
C175-16 Generator Set Engine Engine Oil Screen - Remove and Install
C175-16 Generator Set Engine Engine Oil and Water Pump Drive - Assemble
G3520E Generator Set Engines Water Lines
2012/10/08 Set Engine Valve Lash After Installing All Remanufactured Long Blocks {1102, 1121, 1123, 1209}
2012/10/08 Set Engine Valve Lash After Installing All Remanufactured Long Blocks {1102, 1121, 1123, 1209}
2012/10/08 Set Engine Valve Lash After Installing All Remanufactured Long Blocks {1102, 1121, 1123, 1209}
2012/10/24 New Exhaust Valves Are Used in G3500 and G3500B Engines {1105}
C1.5 and C2.2 Industrial Engines Customer Specified Parameters Table
G3520E Generator Set Engines Cylinder Block
2012/10/15 Later Pre-Chamber Cylinder Heads On Early 3304 Engines Without Drilled Rocker Stands Are Used {1100}
C13, C15, and C18 Tier 4 Final Engines DEF Control Module Power - Test
C13, C15, and C18 Tier 4 Final Engines NOx Conversion Is Low
C13, C15, and C18 Tier 4 Final Engines SCR Catalyst Inlet Temperature Sensor - Test
3500 Generator Sets with Dynamic Gas Blending Fluid Recommendations
2012/10/08 An Improved Hand Operated Fuel Priming Pump Is Available {1258}
3500 Generator Sets with Dynamic Gas Blending Starting the Engine - Natural Gas
2012/10/08 An Improved Hand Operated Fuel Priming Pump Is Available {1258}
C32 Marine Engines Electric Starting Motor - Remove and Install
2012/10/11 Correction to Part Numbers Specific to Generator Arrangement for Certain XQ80 and XQ100 Rental Generator Sets {4450}
3512B and 3512C Petroleum Generator Set Engines Engine Misfires, Runs Rough or Is Unstable
2012/10/18 Improved EMCP4 Software is Now Used on Certain C4.4, C6.6 Cat® Generator Sets {7620}