Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
Show/hide table
Illustration 1 | g03093198 |
Typical example |
Show/hide table
Specification for 4W-6062 Engine Oil Lines Gp and 261-2330 Engine Oil Lines Gp | |||
Item | Qty | Part | Specification Description |
1 | 2 | 0S-1571 Bolt | Use the following sequence to tightening the clamp bolts:
1. Snugly tighten the clamp assembly to the tube. 2. Tighten the clamp assembly to the elbow. 3. Tighten the clamp assembly to the tube. |
2 | 2 | 0S-1594 Bolt | |
3 | 2 | 7N-7697 Plunger | Cooling jet sequence valves must start to open at the following pressure difference is |
Cooling jet sequence valves must be fully open at the following pressure difference is |
|||
4 | 1 | 2W-1053 Plug | Torque to |
5 | 1 | 2W-1969 Bypass Valve | Oil cooler bypass valve must open with the following pressure difference is |
6 | 2 | 6B-9202 Spring | Length under test force is Test force is Free length after test is |
7 | 1 | 2W-1635 Spring | Length under test force is Test force is Free length after test is |
Caterpillar Information System:
C280-12 and C280–16 Marine Engines Engine Oil Filter Housings - Install
3516B Engine Engine Oil Level - Check
797F and 797F XQ Off-Highway Trucks Machine Systems Radiator Grill - Remove and Install
3500 Industrial Engines Engine Oil Pan
3500C Marine Engines Turbocharger Oil Lines
3516B Engine Refill Capacities
3516B Engine Plate Locations and Film Locations
797F and 797F XQ Off-Highway Trucks Machine Systems Engine Shutdown Switch and Disconnect Switch - Remove and Install
3516B Engine Product Description
2014/03/07 New Exhaust Elbows and Bellows Are Used for the Turbine Inlets on Certain G3516B and G3520B Engines {1052, 1059}
C7.1 Industrial Engine Turbocharger - Inspect
797F and 797F XQ Off-Highway Trucks Machine Systems Hood (Rear) - Remove and Install
3500B Engines for Caterpillar Built Power Modules Engine Oil Filter
3512B and 3512C Petroleum Generator Set Engines Crankcase Breather
C7.1 Engines Clean Emissions Module Has High Oxygen Level
C7.1 Industrial Engine Walk-Around Inspection
2012/10/11 New Clamp for Fuel Injection Lines on C6.6 Machine Engines {1251, 1290, 7553}
3500 Generator Set Engines Engine Oil Lines
Piston Ring Gap Alignment Influence on High Blowby and Oil Consumption on All Engines {1000, 1215} Piston Ring Gap Alignment Influence on High Blowby and Oil Consumption on All Engines {1000, 1215}
3500C Marine Engines Fan Drive
C7.1 Industrial Engine Reference Material
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Disassemble - Type 2
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Assemble - Type 2
2012/07/02 Precious Metals Engine Rebuild Kits Are Available for 3306 Machine Engines {1000}