Fuel Cooler - Remove and Install
- Turn the fuel supply to the OFF position.
- Relieve fuel pressure by opening relief valve.
Show/hide table
Illustration 1 g03060459 - Disconnect tube assembly (1) and remove the elbow adapter.
- Disconnect hose assemblies (2) and (3).
Show/hide table
Illustration 2 g03060478 - Remove adapters (4) and (5). Remove elbow assembly (8).
- Remove four bolts (6) and remove fuel cooler (7).
Show/hide table
 |
|
Personal injury or death can result from a fire. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system. Turn the disconnect switch OFF or disconnect the battery when changing fuel filters. |
- Install fuel cooler (7) in the reverse order of removal.
- Tighten adapter (4) and elbow assembly (8) to a torque of
82 ± 5 N·m (60 ± 4 lb ft) .
- Tighten adapter (4) and elbow assembly (8) to a torque of
Caterpillar Information System:
2013/03/15 New Jacket Water Heater System Components Are Used on Certain C27, C32, 3500, and C175 Generator Set Engines {1383}
C1.5 and C2.2 Engines for Caterpillar Built Machines Electronic Control System Components
C18 Marine Engines Exhaust Manifold - Remove and Install
C1.5 and C2.2 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel System - Inspect
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Serial Number Plate
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Bearing (3.5 EVD or Greater) - Replace
C18 Marine Engines Air Cleaner - Remove and Install
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Bearing (Earlier) - Replace
C1.5 and C2.2 Engines for Caterpillar Built Machines Glossary of Electronic Control Terms
G3516C and G3516E Gas Engines Cylinder Head
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel System
C18 Marine Engines Air Starting Motor - Remove and Install
Torque Multipliers, Models 1U-7293, 6V-7820 and 6V-6080{0599, 0765} Torque Multipliers, Models 1U-7293, 6V-7820 and 6V-6080{0599, 0765}
3500 Marine Engines Camshaft Bearing Position
C3.3B and C3.8 Engines for Caterpillar Built Machines Cooling Fan Is Always ON
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Shutdown Occurs Intermittently
C3.3B and C3.8 Engines for Caterpillar Built Machines Fuel Consumption Is Excessive
C18 Marine Engines Atmospheric Pressure Sensor - Remove and Install
C18 Marine Engines Camshaft Position Sensor - Remove and Install
C18 Marine Engines Crankshaft Position Sensor - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Oil Consumption Is Excessive
C18 Marine Engines Coolant Level Sensor - Remove and Install - Jacket Water
C18 Marine Engines Coolant Level Sensor - Remove and Install - SCAC