Crankcase Breather - Install - Unfiltered Breather
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 将塑料管组件 (3) 安装到呼吸器 (1) 上。 确保塑料管组件走线正确。
- 牢固地拧紧软管卡箍 (2)。
- 将夹子 (5) 正确定位。 安装螺栓 (4)（未显示），并用手拧紧。
- 将塑料管组件 (3) 安装到夹子 (5) 中。
- 将螺栓 (4)（未显示）拧紧至扭矩为
22 N·m (195 lb in) 。
Show/hide table
| |
| 图 1 | g02727965 |
Caterpillar Information System:
C7.1 (Mech) Industrial Engine Crankcase Breather - Remove - Filtered Breather
C7.1 (Mech) Industrial Engine Crankcase Breather - Install - Filtered Breather
C7.1 (Mech) Industrial Engine Connecting Rod Bearings - Remove - Connecting Rods in Position
C7.1 (Mech) Industrial Engine Connecting Rod Bearings - Install - Connecting Rods in Position
C7.1 (Mech) Industrial Engine Camshaft Gear - Remove and Install
C7.1 (Mech) Industrial Engine Camshaft Bearings - Remove and Install
C7.1 (Mech) Industrial Engine Camshaft - Remove and Install
C7.1 (Mech) Industrial Engine Alternator - Remove
C7.1 (Mech) Industrial Engine Alternator - Install
C7.1 (Mech) Industrial Engine Accessory Drive - Remove and Install - Accessory Drive SAE "A"
C175-16 and C175-20 Generator Set Engines Pressure Control Valve - Oil Regulator Valve and Oil Bypass Valve
PMG3516 Power Module Coolant Temperature Regulator - Replace
C7.1 (Mech) Industrial Engine Crankcase Breather - Remove - Unfiltered Breather
C7.1 (Mech) Industrial Engine Crankshaft - Install
C7.1 (Mech) Industrial Engine Crankshaft - Remove
C7.1 (Mech) Industrial Engine Crankshaft Front Seal - Remove and Install
C7.1 (Mech) Industrial Engine Crankshaft Gear - Remove and Install
C7.1 (Mech) Industrial Engine Crankshaft Main Bearings - Remove and Install - Crankshaft in Position
C7.1 (Mech) Industrial Engine Crankshaft Rear Seal - Install
C7.1 (Mech) Industrial Engine Crankshaft Rear Seal - Remove
C7.1 (Mech) Industrial Engine Cylinder Head - Install
C7.1 (Mech) Industrial Engine Cylinder Head - Remove
C7.1 (Mech) Industrial Engine Electric Starting Motor - Remove and Install
C7.1 (Mech) Industrial Engine Engine Oil Cooler - Install