C15 and C18 Engines for Caterpillar Built Machines Caterpillar


Electric Starting Motor

Usage:

826K 2L3


图 1g02560026

表 1
技术规格,用于 207-1556 电动起动马达总成 
项目  数量  零件  技术规格说明 
6V-8188 螺母  拧紧至扭矩为 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in)。 
250-8279 电磁阀套件  20V 和 25 °C (77 °F) 下的电流消耗:
1. 对于吸合绕组为 57 安培
2. 对于保持绕组为 16 安培
3. 最大额定电流为 850 安培 
小齿轮和壳体之间的间隙为 9.1 mm (0.36 inch)。 
6V-8378 螺母  拧紧至扭矩为 2.6 ± 0.8 N·m (23.0 ± 7.1 lb in)。 
6V-8188 螺母  蓄电池端子螺母(3)最多可使用三个电缆或导线端子。 两个端子最高不低于 0 AWG。
拧紧至扭矩为 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in)。 
6V-8378 螺母  开关端子必须用热收缩管绝缘。 不要使用模压端子。
拧紧至扭矩为 2.6 ± 0.8 N·m (23.0 ± 7.1 lb in)。 
6V-8188 螺母  拧紧至扭矩为 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in)。 
拧紧至扭矩为 8 ± 3 N·m (71 ± 27 lb in)。 
当从小齿轮端观看电起动马达时,马达顺时针旋转。
25 °C (77 °F) 下的无负载状态
1. 转速为 7643 ± 1683 rpm
2. 电流消耗为 76.5 ± 14.5 安培
3. 电压为 23 V 
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.