Camshaft Position Sensor - Remove and Install
- Disconnect harness assembly (2).
- Remove bolt (3) and camshaft position sensor (1).
- Remove the O-ring seal from camshaft position sensor (1).
Show/hide table
Illustration 1 | g02256633 |
Photo showing the location of the camshaft position sensor. |
Show/hide table
Illustration 2 | g02228214 |
- Install camshaft position sensor (1) in reverse order of removal.
- Install a new O-ring seal on camshaft position sensor (1). Lubricate the O-ring seal with clean engine oil.
- Tighten bolt (3) to a torque of
28 ± 7 N·m (21 ± 5 lb ft) .
- Tighten bolt (3) to a torque of
Caterpillar Information System:
2010/08/26 An Improved Locknut Is Now Used to Tighten the Exhaust Manifolds onto the Cylinder Heads of Certain Engines {1059, 7553}
2010/08/26 An Improved Locknut Is Now Used to Tighten the Exhaust Manifolds onto the Cylinder Heads of Certain C15 Engines and C-15 Engines {1059, 7553}
C27 and C32 Industrial Engines Atmospheric Pressure Sensor - Remove and Install
C13, C15, and C18 Tier 4 Interim Engines Speed/Timing - Test
C18 Marine Generator Set Electronic Modular Control Panel 3 (EMCP 3) - If Equipped
3512C HD Locomotive Engine Monitoring System
C27 and C32 Engines for Caterpillar Built Machines Cooling System
C27 and C32 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install - Single Oil Pan
3412C Generator Sets Generator Lead (Round Cable) - Check - If Equipped
3512C HD Locomotive Engine System Pressure Release
3512C HD Locomotive Engine Refill Capacities and Recommendations
C27 and C32 Industrial Engines Housing (Rear) - Install
2010/08/23 New Locknuts for the Exhaust Manifold Are Available for Certain Truck Engines {1059}
2010/08/23 New Locknuts for the Exhaust Manifold Are Available for Certain Commercial Engines {1059}
3512C HD Locomotive Engine After Stopping Engine
3512C HD Locomotive Engine Engine Oil Level - Check
2010/09/17 New Silicone Power Cables Are Now Used For Power Connections On Certain Cat Generator Sets {1408, 4460}
C27 Generator Set Overhaul Considerations
3512C HD Locomotive Engine Belts - Inspect/Adjust/Replace
3512C HD Locomotive Engine Cooling System Coolant (DEAC) - Change
2010/08/23 Use Proper Procedures with Speed/Timing Sensor Diagnostic Codes for C175 Generator Set Engines {1408, 1439, 1912}
C9.3 Tier 4 Interim Engines Diesel Particulate Filter Temperature Is High
C27 and C32 Engines for Caterpillar Built Machines Crankshaft Position Sensor - Remove and Install
G3304B and G3306B Engines Cover Group (Front Housing)