Atmospheric Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect hose assemblies (1) and (2).
- Remove bolts (4) and position manifold (3) out of the way.
- Remove bolts (5) and remove bracket (6).
Show/hide table
Illustration 2 g02252993 - Disconnect harness assembly (7) and remove atmospheric pressure sensor (8).
Show/hide table
Illustration 1 | g02252733 |
View from the front of the engine. |
- Install atmospheric pressure sensor (8) in the reverse order of removal.
- Tighten atmospheric pressure sensor (8) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
- Tighten atmospheric pressure sensor (8) to a torque of
Caterpillar Information System:
C13, C15, and C18 Tier 4 Interim Engines Speed/Timing - Test
C18 Marine Generator Set Electronic Modular Control Panel 3 (EMCP 3) - If Equipped
3512C HD Locomotive Engine Monitoring System
C27 and C32 Engines for Caterpillar Built Machines Cooling System
C27 and C32 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install - Single Oil Pan
3412C Generator Sets Generator Lead (Round Cable) - Check - If Equipped
3512C HD Locomotive Engine System Pressure Release
3512C HD Locomotive Engine Refill Capacities and Recommendations
C27 and C32 Industrial Engines Housing (Rear) - Install
C27 and C32 Industrial Engines Housing (Rear) - Remove
Inspection, Maintenance, and Repair of Operator Protective Structures (OPS) and Attachment Installation Guidelines for All Earthmoving Machinery, If Equipped {7323, 7325} Inspection, Maintenance, and Repair of Operator Protective Structures (OPS) and Attachment Installation Guidelines for All Earthmoving Machinery, If Equipped {7323, 7325}
3512C HD Locomotive Engine Configuration Parameters
2010/08/26 An Improved Locknut Is Now Used to Tighten the Exhaust Manifolds onto the Cylinder Heads of Certain C15 Engines and C-15 Engines {1059, 7553}
2010/08/26 An Improved Locknut Is Now Used to Tighten the Exhaust Manifolds onto the Cylinder Heads of Certain Engines {1059, 7553}
C27 and C32 Industrial Engines Camshaft Position Sensor - Remove and Install
2010/08/23 New Locknuts for the Exhaust Manifold Are Available for Certain Truck Engines {1059}
2010/08/23 New Locknuts for the Exhaust Manifold Are Available for Certain Commercial Engines {1059}
3512C HD Locomotive Engine After Stopping Engine
3512C HD Locomotive Engine Engine Oil Level - Check
2010/09/17 New Silicone Power Cables Are Now Used For Power Connections On Certain Cat Generator Sets {1408, 4460}
C27 Generator Set Overhaul Considerations
3512C HD Locomotive Engine Belts - Inspect/Adjust/Replace
3512C HD Locomotive Engine Cooling System Coolant (DEAC) - Change
2010/08/23 Use Proper Procedures with Speed/Timing Sensor Diagnostic Codes for C175 Generator Set Engines {1408, 1439, 1912}