Fuel Priming Pump - Remove and Install
- If equipped with a sound suppression arrangement, refer to Special Instruction, "Installation of the 351-3820 Sound Suppression Ar (If Equipped)" or Special Instruction, "Installation of the 350-2312 Sound Suppression Ar (If Equipped)" for specific panel locations and the correct removal or installation procedure.
- Turn the power disconnect switch to the OFF position.
- Turn the fuel supply to the OFF position.
Show/hide table
Illustration 1 g01961468 - Disconnect hoses (1). Disconnect harness assemblies (2). Remove bolts (3).
- Remove fuel priming pump (4).
- Install fuel priming pump (4) in the reverse order of removal.
Caterpillar Information System:
3508, 3512 and 3516 Generator Set Engines Air Inlet Shutoff - Remove and Install
An Incorrect Check Valve Has Been Used in Certain 2007 On-Highway Truck Engines{1262} An Incorrect Check Valve Has Been Used in Certain 2007 On-Highway Truck Engines{1262}
C4.4 Industrial Engine Ordering Replacement Parts
Diagnostic Process for Fuel Rail Pressure Sensor{1718} Diagnostic Process for Fuel Rail Pressure Sensor{1718}
3508, 3512 and 3516 Generator Set Engines Manual Shutoff - Remove and Install
Installation of the Bracket for a Fuel Injection Line for Certain C7 Engines{1252, 1254} Installation of the Bracket for a Fuel Injection Line for Certain C7 Engines{1252, 1254}
C7.1 Industrial Engine and Generator Set Valve Position Sensor - Test
3508, 3512 and 3516 Generator Set Engines Alternator - Remove and Install
C7.1 Industrial Engine and Generator Set Intake Manifold Air Pressure Is Low
C13, C15, and C18 Tier 4 Interim Engines NRS Exhaust Gas Temperature Is High
3508C, 3512C, and 3516C Locomotive Engines Event Codes
C4.4 Industrial Engine Fuel Related Components in Cold Weather
G3304B and G3306B Engines Sensor Signal (Analog, Passive) - Test
793F Off-Highway Truck Cab Air Filter - Clean/Replace
793F Off-Highway Truck Cable (Truck Body Retaining) - Inspect
3508C, 3512C, and 3516C Locomotive Engines Configuration Parameters
C7.1 Industrial Engine and Generator Set Diesel Particulate Filter Temperature Is Low
797F and 797F XQ Off-Highway Truck Hydraulic System Gear Pump (Brake Cooling, Hoist)
G3304B and G3306B Engines Carburetor (High Pressure Gas) - Adjust
320D Excavator Rollover Protective Structure (ROPS) - Inspect
G3304B and G3306B Engines Engine Timing Does Not Match Programmed Timing
793F Off-Highway Truck Differential and Final Drive Oil - Inspect
G3520E Generator Set Engines Sensor Signal (PWM) - Test
793F Off-Highway Truck Indicators and Gauges - Test