Gear Pump (Brake Cooling, Hoist)
Show/hide table
| |
| Illustration 1 | g01964235 |
Displacement per revolution ...
Rotation ... Clockwise
Maximum pressure ...
Maximum speed ... 2500 rpm
(1) Torque for eight nuts ...
Show/hide table
| |
| Illustration 2 | g01964236 |
|
Section A-A | |
Note: Each section of the pump has the same specifications.
(2) Assemble the retaining ring opening over the drain hole.
(3) Assemble the shaft seals on either side of the retaining ring with the sealing lip of the shaft seal facing outward.
Show/hide table
| |
| Illustration 3 | g01964234 |
|
Section B-B | |
(4) Pressure plates must be assembled with the chamfers on the outlet side.
Caterpillar Information System:
C7.1 Industrial Engine and Generator Set Diesel Particulate Filter Temperature Is Low
3508C, 3512C, and 3516C Locomotive Engines Configuration Parameters
793F Off-Highway Truck Cable (Truck Body Retaining) - Inspect
793F Off-Highway Truck Cab Air Filter - Clean/Replace
G3304B and G3306B Engines Sensor Signal (Analog, Passive) - Test
793F Off-Highway Truck Engine Supplement Fuel Priming Pump - Remove and Install
3508, 3512 and 3516 Generator Set Engines Air Inlet Shutoff - Remove and Install
An Incorrect Check Valve Has Been Used in Certain 2007 On-Highway Truck Engines{1262} An Incorrect Check Valve Has Been Used in Certain 2007 On-Highway Truck Engines{1262}
C4.4 Industrial Engine Ordering Replacement Parts
Diagnostic Process for Fuel Rail Pressure Sensor{1718} Diagnostic Process for Fuel Rail Pressure Sensor{1718}
3508, 3512 and 3516 Generator Set Engines Manual Shutoff - Remove and Install
Installation of the Bracket for a Fuel Injection Line for Certain C7 Engines{1252, 1254} Installation of the Bracket for a Fuel Injection Line for Certain C7 Engines{1252, 1254}
G3304B and G3306B Engines Carburetor (High Pressure Gas) - Adjust
320D Excavator Rollover Protective Structure (ROPS) - Inspect
G3304B and G3306B Engines Engine Timing Does Not Match Programmed Timing
793F Off-Highway Truck Differential and Final Drive Oil - Inspect
G3520E Generator Set Engines Sensor Signal (PWM) - Test
793F Off-Highway Truck Indicators and Gauges - Test
G3304B and G3306B Engines Electrical Power Supply - Test
793F Off-Highway Truck Display and Camera - Clean - If Equipped
C7.1 Industrial Engine and Generator Set Welding Precaution
C32 Marine Engine Refill Capacities and Recommendations
3508, 3512 and 3516 Generator Set Engines Crankcase Breather - Remove and Install
793F Off-Highway Truck Front Wheel Oil Sample - Obtain