A One-Piece Spring Seat Is Now Used In The Governor{1264}
Usage:
3406, 3408, 3412 Industrial Engines (90U, 67U, 38S)
Description of Change: A one-piece spring seat is now used in place of the former two-piece spring seat, in dash pot governors on 3406, 3408, and 3412 Industrial Engines. With the one-piece spring seat, it is easier to hold the 2 ± 1% change in RPM from "high idle" to "full load".
Adaptable As: A direct replacement as shown in the chart that follows:
Caterpillar Information System:
1978/06/26 New Dashpot Spring Gives A Reduction In "Overshoot"{1264}
1978/06/26 Do Not Use Plastic Tubing And Compression Fittings Without An Insert As A Fuel Supply Line{1274}
1978/06/26 Changes Made To Warning Plates, Decals And Service Literature For Caterpillar Machines{7405}
1978/06/26 Mounting For Transmission/Torque Converter Oil Cooler Improved To Decrease Vibration{1375}
1978/06/19 Grind Material From Boss On Parts Service Cylinder Block To Give Clearance For Starting Motor Mounting Bolt{1201,1453}
1978/06/19 5P8700 Lifting Brackets Permit Cylinder Head Assembly To Be Removed And Installed{0644,1100}
1978/06/19 New, Stronger " Drive Ratchet Available{0610}
1978/06/19 Lubrication For A Rebuilt Engine{0374,1000}
1978/06/19 New Information On Reusable Cylinder Liners{1216}
1978/06/12 New Vibration Damper Has Stronger Mounting Flange To Prevent Possible Cracks{1205}
1978/06/12 Clip Added To Compressor Lines Group To Keep Oil Line Away From Exhaust Manifold{1307,1065}
1978/06/12 5P8626 Tool Bit Available To Machine The 5P6595 And 5P8607 Liner Seat Inserts{0664}
1978/06/26 Fluid-Type Vibration Damper Now Used Instead Of Rubber-Type Damper{1205}
1978/07/03 Use The Drive Sleeve On The Fuel Injection Pump Camshaft Only One Time{1286,1256,1251}
1978/07/03 Use New Seal Drivers To Install Primary Seals In Vickers Pumps{0622}
1978/07/03 Improved Seal Rings For Turbine End Of Turbochargers{1052}
1978/07/03 New BrakeSaver Rotor Support Prevents Damage To Seals And Stator{1155}
1978/07/03 New One-Piece Flywheel Housing Gasket{1157,1201}
1978/07/03 Disconnected Air Cleaner Hose Can Cause Engine Damage{1058,1051}
1978/07/10 New Flange-Type Seal Used At Rear Of Crankshaft{1161}
1978/07/10 Drill Hole In Handle Of Early 5P3520 Spanner Wrenches For Use With 5P8675 Extension Handle{0620}
1978/08/07 Four New Contact Points Added To 5P6524 Engine Timing Indicator Group{0653}
1978/08/07 New Glow Plug Wiring Harness Prevents Short Circuit{1403}
1978/08/07 Remove Fuel Injection Nozzles Before The Bottom Surface Of A Cylinder Head Is Cleaned{1254,1101}