Fuel Injection Nozzles
Show/hide table
Illustration 1 | g01335248 |
Typical example |
(1) Tighten the fuel injection nozzles to the following torque.
- C1.5 and C2.2 ... 64 N·m (47 lb ft)
Note: Remove the original seat washer from the hole for the fuel injector. Do not reuse the original seat washer.
Note: Apply a 2 mm (0.0787 inch) bead of 239-3312 Sealant to the first 6 mm ( 0.2362 inch) of the thread to the fuel injection nozzle.
Show/hide table
Injector Opening Pressures     | |
Engine Model     | Opening pressure     |
C1.5     | 14700 kPa (2132 psi)     |
C2.2     | 14700 kPa (2132 psi)     |
Leakage in 10 seconds ... 0 drops
Caterpillar Information System:
C1.5 and C2.2 Generator Sets Fuel Injection Pump
C1.5 and C2.2 Generator Sets Fuel Injection Lines
C1.5 and C2.2 Generator Sets Engine Design
C15 and C18 Petroleum Generator Sets Generator Bearing - Lubricate
795F AC and 795F AC XQ Off-Highway Trucks Engine Valve Lash - Check/Adjust
C6.6 Marine Generator Set Belts - Inspect/Adjust/Replace - Single Belt
C6.6 Marine Generator Set Belts - Inspect/Adjust/Replace - Two Belt Set
C6.6 Marine Generator Set Maintenance Interval Schedule
C6.6 Marine Generator Set Engine Wiring Information
C18 Generator Set Engines Sensor Signal (PWM) - Test
Registration of Product Link in EquipmentManager{7606} Registration of Product Link in EquipmentManager{7606}
C6.6 Marine Generator Set Refill Capacities and Recommendations
C1.5 and C2.2 Generator Sets Lifter Group
C1.5 and C2.2 Generator Sets Rocker Shaft
C1.5 and C2.2 Generator Sets Valve Mechanism Cover
C1.5 and C2.2 Generator Sets Cylinder Head Valves
C1.5 and C2.2 Generator Sets Cylinder Head
C1.5 and C2.2 Generator Sets Exhaust Manifold
C1.5 and C2.2 Generator Sets Camshaft
C1.5 and C2.2 Generator Sets Engine Oil Relief Valve
C1.5 and C2.2 Generator Sets Water Temperature Regulator
C1.5 and C2.2 Generator Sets Cylinder Block
C1.5 and C2.2 Generator Sets Crankshaft
C1.5 and C2.2 Generator Sets Connecting Rod Bearing Journal