Engine Valve Lash - Check/Adjust
Show/hide table
 |
|
确保在进行此保养时不能起动发动机。 不要使用起动马达带动飞轮，以免造成人身伤害。 热的发动机零部件可能造成烫伤。 在测量/调整气门间隙前要等一定时间，让发动机冷下来。 |
Show/hide table
|
|
有电击危险。电子单体喷油器使用90-120伏电压。 |
Show/hide table
| 注意 |
|---|
|
只有获得资格的维修人员才能进行该项保养工作。 请参考系统操作/测试和调整手册, "气门间隙和气门桥臂的调整"标题或咨询当地的卡特彼勒代理商有关完整的气门间隙调整程序。 气门间隙调整不适当的卡特彼勒发动机工作效率会降低。 效率降低会使燃料消耗量增加和/或缩短发动机部件寿命。 |
作为润滑和预防性保养计划的一部分，Caterpillar 推荐采用本步骤，从而有助于实现发动机的最长使用寿命。
- 准备维修的机器。 请参阅操作和保养手册, "使机器作好保养准备"。
- 有关检查发电机气门间隙的信息，请参阅系统操作、测试和调整, KENR9188 或咨询 Cat 代理商。
Caterpillar Information System:
C6.6 Marine Generator Set Belts - Inspect/Adjust/Replace - Single Belt
C6.6 Marine Generator Set Belts - Inspect/Adjust/Replace - Two Belt Set
C6.6 Marine Generator Set Maintenance Interval Schedule
C6.6 Marine Generator Set Engine Wiring Information
C18 Generator Set Engines Sensor Signal (PWM) - Test
Registration of Product Link in EquipmentManager{7606} Registration of Product Link in EquipmentManager{7606}
C6.6 Marine Generator Set Refill Capacities and Recommendations
C18 Generator Set Engines Sensor Signal (Analog, Passive) - Test
A J1939 Device Not Responding (231-12) Diagnostic Code is Occurring on C11 and C13 On-Highway Engines{1920, 7620} A J1939 Device Not Responding (231-12) Diagnostic Code is Occurring on C11 and C13 On-Highway Engines{1920, 7620}
C18 Generator Set Engines Sensor Signal (Analog, Active) - Test
C18 Generator Set Engines Injector Solenoid - Test
C18 Generator Set Engines Indicator Lamp - Test
C15 and C18 Petroleum Generator Sets Generator Bearing - Lubricate
C1.5 and C2.2 Generator Sets Engine Design
C1.5 and C2.2 Generator Sets Fuel Injection Lines
C1.5 and C2.2 Generator Sets Fuel Injection Pump
C1.5 and C2.2 Generator Sets Fuel Injection Nozzles
C1.5 and C2.2 Generator Sets Lifter Group
C1.5 and C2.2 Generator Sets Rocker Shaft
C1.5 and C2.2 Generator Sets Valve Mechanism Cover
C1.5 and C2.2 Generator Sets Cylinder Head Valves
C1.5 and C2.2 Generator Sets Cylinder Head
C1.5 and C2.2 Generator Sets Exhaust Manifold
C1.5 and C2.2 Generator Sets Camshaft