Electronic Unit Injector Sleeve - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
E | 221-9777 | Sleeve Installer | 1 |
F | 4C-5552 | Large Bore Brush | 1 |
G | 4C-9507 | Retaining Compound | - |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (F) to clean the bore for the electronic unit injector sleeve.
Show/hide table
Illustration 1 g01108541 - Install new O-ring seals (2) on the new electronic unit injector sleeve (1). Lubricate the O-ring seals with clean engine oil.
- Apply a thin coating of Tooling (G) around the outer circumference of electronic unit injector sleeve (1) at Area (X).
- Place electronic unit injector sleeve (1) on Tooling (E).
- Position the electronic unit injector sleeve in the cylinder head. Use a hammer and Tooling (E) to install the electronic unit injector sleeve in the cylinder head.
Note: Allow Tooling (G) to cure for two hours at
End By:
- Install the electronic unit injectors. Refer to Disassembly and Assembly, "Electronic Unit Injector - Install".
Caterpillar Information System:
3176C, 3406E and 3456 Industrial Engines Event Codes
3406E and C15 Marine Engines Circuit Breakers
3176C, 3406E and 3456 Industrial Engines Diagnostic Trouble Codes
C9 Petroleum Engines Electronic Unit Injector - Install
C9 Petroleum Engines Electronic Unit Injector - Remove
C9 Petroleum Engines Electronic Unit Injector Sleeve - Remove
G3520B Engines Engine Oil Pressure Sensor
3176C, 3406E and 3456 Industrial Engines Air Shutoff - Test
C9.3 Marine Auxiliary Engines Turbocharger - Inspect
797F Off-Highway Truck Power Train Transmission Hydraulic Control - Remove
797F Off-Highway Truck Power Train Screen (Transmission Scavenge) - Remove and Install
797F Off-Highway Truck Power Train Relief Valve (Transmission Main) - Assemble
C15 and C18 Petroleum Generator Sets Self-Diagnostics
C9 Petroleum Engines Inlet and Exhaust Valve Springs - Remove and Install
797F Off-Highway Truck Power Train Transmission Hydraulic Control - Install
797F Off-Highway Truck Power Train Transmission Hydraulic Control - Disassemble
797F Off-Highway Truck Power Train Transmission Hydraulic Control - Assemble
C9 Petroleum Engines Engine Oil Filter Base and Oil Cooler - Install
3176C, 3406E and 3456 Industrial Engines ECM/Personality Module - Test
797F Off-Highway Truck Power Train Modulating Valve (Transmission Clutch Engaging) - Remove
C15 and C18 Petrolem Generator Set Engines Engine Monitoring System
3176C Engine for Caterpillar Built Machines Diagnostic Capabilities
797F Off-Highway Truck Power Train Modulating Valve (Transmission Clutch Engaging) - Install
C15 and C18 Petrolem Generator Set Engines Engine Top Speed Is Not Obtained