Pump Control (Negative Flow) - Adjust
Adjust the negative flow control if the flow test results differ greatly from the specification.
Show/hide table
| |
| Illustration 1 | g02100279 |
|
Pump Compartment (1) Adjustment screw (2) Locknut (3) Adjustment screw (4) Locknut | |
Note: Use the same procedure for both pumps. Use locknut (1) and adjustment screw (2) to adjust the drive pump. Use locknut (4) and adjustment screw (3) to adjust the idler pump.
- Loosen locknut (2).
- Turn adjustment screw (1) until the negative flow rate is adjusted to the correct specification.
Note: A clockwise adjustment of adjustment screw (1) and adjustment screw (3) increases the flow rate. A counterclockwise adjustment decreases the flow rate.
Note: A quarter turn of adjustment screw (1) will change the flow rate approximately
17.9 L/min (4.7 US gpm) which is approximately100 kPa (15 psi) . - Tighten locknut (2) to a torque of
16 N·m (12 lb ft) . - Adjust the idler pump. Use locknut (4) and adjustment screw (3) to adjust the idler pump.
Caterpillar Information System:
340F Excavator Machine Systems Pump Control (Negative Flow) - Test
D10T2 Fan Pump Update {1387, 5070} D10T2 Fan Pump Update {1387, 5070}
340F Excavator Machine Systems Accumulator (Swing) - Test and Charge
D5R and D6N Track-Type Tractor Power Train Main Drive Shaft - Remove and Install
340F Excavator Machine Systems Joystick and Pedal - Calibrate
340F Excavator Machine Systems Specifications
340F Excavator Machine Systems Gear Pump (Pilot) - Test
340F Excavator Machine Systems Pump Control (Output Flow) - Adjust
340F Excavator Machine Systems Main Pump (Flow) - Test - Hydraulic Power
340F Excavator Machine Systems Relief Valve (Crossover) - Test and Adjust
340F Excavator Machine Systems Travel Motor - Test - Measurement of Case Drain Oil
340F Excavator Machine Systems Swing Bearing Movement - Measure
340F Excavator Machine Systems Pump Control (Output Flow) - Test - One Pump Calibration (Optional Test)
340F Excavator Machine Systems Relief Valve (Pilot) - Test and Adjust
980L Medium Wheel Loader Power Train, Steering, Braking, Hydraulic, and Machine Systems Steering Control - Control System
980M and 982M Medium Wheel Loader Power Train, Steering, Braking, Hydraulic, and Machine Systems Piston Pump Margin Pressure (Hydraulic Fan) - Test and Adjust
854K Wheel Dozer Windows - Clean
Reference Guide for a Proper Failure Analysis by CAT Dealer {0374, 1000} Reference Guide for a Proper Failure Analysis by CAT Dealer {0374, 1000}
992K Wheel Loader Plate Locations and Film Locations
D11 Main Frame Inspection and Weld Repair Procedure {0679, 7051} D11 Main Frame Inspection and Weld Repair Procedure {0679, 7051}
950 GC Wheel Loader Automatic Lubrication System - If Equipped
980L Medium Wheel Loader Power Train, Steering, Braking, Hydraulic, and Machine Systems Hydraulic Fan Speed - Test and Adjust
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Diesel Particulate Filter Regeneration Does Not Occur
Cab Pressurizer Now Available as a Group for Underground Articulated Trucks and Load Haul Dump Machines {7311} Cab Pressurizer Now Available as a Group for Underground Articulated Trucks and Load Haul Dump Machines {7311}