G3520B Industrial Engines Caterpillar


Electronic Control System Operation

Usage:

G3520B GLF
Engines with 20 cylinders have two Electronic Control Modules (ECM). The ECM controls most of the functions of the engine.

The operator's interface with the engine control is provided by the Caterpillar Electronic Technician (ET) and by the optional control panel. For information on Cat ET, refer to Systems Operation/Testing and Adjusting, "Electronic Service Tools".

Many of the engine control's parameters can be programmed for the specific site. For information on the programmable parameters, refer to Systems Operation/Testing and Adjusting, "Electronic Control System Parameters".

The starting motor solenoid, the Gas Shutoff Valve (GSOV), and other components are used to control start-up and shutdown. For information on start/stop sequencing, refer to Systems Operation/Testing and Adjusting, "Start/Stop Control".

The ECM provides the timing and the voltage for ignition. For information on ignition control, refer to Systems Operation/Testing and Adjusting, "Ignition System".

Feedback from sensors and adjustment of the fuel metering valve enable control of the exhaust emissions. For information on air/fuel ratio control, refer to Systems Operation/Testing and Adjusting, "Air/Fuel Ratio Control".

The desired speed is maintained through control of the throttle actuator. For information on governing of the engine, refer to Systems Operation/Testing and Adjusting, "Engine Governing".

The ECM controls the compressor bypass group. For information on the compressor bypass group, refer to Systems Operation/Testing and Adjusting, "Compressor Bypass".

Other sensors enable the ECM to monitor the engine operation. For information on engine monitoring and protection, refer to Systems Operation/Testing and Adjusting, "Engine Monitoring System".

The monitoring system includes the Integrated Temperature Sensing Module (ITSM). The ITSM monitors the engine's exhaust temperatures. For information on the module, refer to Systems Operation/Testing and Adjusting, "Integrated Temperatutre Sensing Module (ITSM)".

Illustration 1 is a typical diagram of the components in the engine's electronic control system.




Illustration 1g01407145

Block diagram of the components

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.