Belts - Inspect/Adjust/Replace
皮带张力应在发动机最初运行的 20 至 40 小时之间进行目视检查。
皮带张力在首次检查后,应每隔 250 工作小时或 1 年检查一次。
- 卸下螺栓 (1) 和防护罩组件 (2)。
Show/hide table
图 2 g01030493 (3) 皮带张紧器 - 检查皮带张紧器 (3) 有无异常噪声、过松和/或轴承振动现象。
- 为使发动机性能最大化,检查传动皮带是否磨损和断裂。 更换损坏或磨损的皮带。 如果安装了新皮带的话,应在发动机在额定转速运转30分钟之后再次检查皮带张紧度。
- 安装皮带护罩。
Show/hide table
图 1 | g01030477 |
Caterpillar Information System:
G3500 Engines Safety Messages
C15 On-Highway Engine Fuel Filter Base - Remove
C18 Marine Engines Indicator Lamp - Test
3500B Engines Fuel Filter Housing - Install
3500B Engines Fuel Filter Housing - Remove
2007/05/01 Water Pump Weepage Versus Water Pump Leakage {1361}
2007/05/14 Water Pump Weepage Versus Water Pump Leakage {1361}
C18 Marine Engines Sensor Supply - Test
2007/04/30 Change to the Maintenance Interval Schedule {1100, 1102, 1121, 1123, 1210}
CX35 On-Highway Transmission Plate Locations and Film Locations
C32 Petroleum Engines Air Shutoff - Test
3408B and 3408C Industrial and Marine Engines Auxiliary Drive Pulley
Emulsion Has Been Found in Certain Applications{1107, 1306, 1317, 1326} Emulsion Has Been Found in Certain Applications{1107, 1306, 1317, 1326}
C18 Generator Set Engines Exhaust Has Excessive Black Smoke
2007/07/09 A Guard Kit Is Available {1205}
C15 On-Highway Engine Fuel Filter Base - Install
3408C and 3412C Marine Engines Magnetic Pickup
G3520B Industrial Engines Electronic Control System Operation
G3520B Industrial Engines Electronic Control Module (ECM)
C15 On-Highway Engine Fuel Control Manifold (ARD) - Remove
G3520B Industrial Engines Engine Governing
G3520B Industrial Engines Integrated Temperature Sensing Module
G3520B Industrial Engines Electronic Control System Parameters
2008/03/17 New Product Link Hardware Is Now Available {7606}