Magnetic Pickup
Show/hide table
Illustration 1 | g01387330 |
Typical example |
(A) Distance between end of magnetic pickup and ring gear ... 0.69 ± 0.14 mm (0.027 ± 0.006 inch)
To set the distance between the magnetic pickup and the ring gear with the engine stopped, use the following procedure:
- Turn the magnetic pickup until the magnet is against the ring gear tooth.
- To ensure that the magnetic pickup is against a tooth on the ring gear, look through the opening that is in the flywheel housing.
- Back out the magnetic pickup by 180 ± 36 degrees. Tighten locknut (1) .
Torque for the locknut ... 25 ± 5 N·m (18 ± 4 lb ft)
Caterpillar Information System:
C15 On-Highway Engine Fuel Filter Base - Install
2007/07/09 A Guard Kit Is Available {1205}
C18 Generator Set Engines Exhaust Has Excessive Black Smoke
Emulsion Has Been Found in Certain Applications{1107, 1306, 1317, 1326} Emulsion Has Been Found in Certain Applications{1107, 1306, 1317, 1326}
C9 Marine Auxiliary and Generator Set Engines Belts - Inspect/Adjust/Replace
G3500 Engines Safety Messages
C15 On-Highway Engine Fuel Filter Base - Remove
C18 Marine Engines Indicator Lamp - Test
3500B Engines Fuel Filter Housing - Install
3500B Engines Fuel Filter Housing - Remove
2007/05/01 Water Pump Weepage Versus Water Pump Leakage {1361}
2007/05/14 Water Pump Weepage Versus Water Pump Leakage {1361}
G3520B Industrial Engines Electronic Control System Operation
G3520B Industrial Engines Electronic Control Module (ECM)
C15 On-Highway Engine Fuel Control Manifold (ARD) - Remove
G3520B Industrial Engines Engine Governing
G3520B Industrial Engines Integrated Temperature Sensing Module
G3520B Industrial Engines Electronic Control System Parameters
2008/03/17 New Product Link Hardware Is Now Available {7606}
325D and 329D Excavators and 325D Material Handler Machine System Specifications Control Manifold (Pilot Oil)
C7 On-highway Engine Air Inlet Elbow
G3520B Industrial Engines Engine Sensors
G3520B Industrial Engines Ignition System
C15 On-Highway Engine Fuel Control Manifold (ARD) - Disassemble