ECM Mounting Bracket - Remove and Install
开始:
- 拆下电子控制模块。 请参阅拆解和组装, "电子控制模块 - 拆卸和安装"。
- 从夹子 (5) 上卸下塑料管组件 (3) 和组件 (4)。
- 剪断电缆扎带,然后将发动机配线线束放在远离安装支架的位置 (2) 处。
- 卸下螺栓 (1),然后从缸盖上卸下安装支架 (2)。
- 如有必要,请从安装支架 (2) 上卸下夹子 (5)。
Show/hide table
图 1 | g01254468 |
典型实例 |
- 确保电子控制模块的安装支架清洁且无损坏。 如有必要,请更换安装支架。
Show/hide table
图 2 g01254468 典型实例 - 如有必要,将夹子 (5) 安装在安装支架 (2) 上。
- 将安装支架 (2) 放置于在缸盖上。 安装螺栓 (1)。 将螺栓拧紧至扭矩
22 N·m (16 lb ft) 。 - 将发动机配线线束放置于安装支架 (2) 上。 使用新的电缆扎带固定发动机配线线束。
- 将塑料管组件 (3) 和组件 (4) 安装在夹子 (5) 上。
结束:
- 安装电子控制模块。 请参阅拆解和组装, "电子控制模块 - 拆卸和安装"。
Caterpillar Information System:
C4.4 Industrial Engine Cylinder Head - Remove
C4.4 Industrial Engine Cylinder Head - Install
C4.4 Industrial Engine Crankshaft Timing Ring - Remove and Install
C4.4 Industrial Engine Crankshaft Rear Seal - Remove
C4.4 Industrial Engine Crankshaft Rear Seal - Install
C4.4 Industrial Engine Crankshaft Pulley - Remove and Install - Engines With an Automatic Belt Tensioner
C4.4 Industrial Engine Crankshaft Pulley - Remove and Install - Engines Without an Automatic Belt Tensioner
C4.4 Industrial Engine Crankshaft Position Sensor - Remove and Install
C4.4 Industrial Engine Crankshaft Main Bearings - Remove and Install - Crankshaft in Position
C4.4 Industrial Engine Crankshaft Gear - Remove and Install
C4.4 Industrial Engine Crankshaft Front Seal - Remove and Install
C4.4 Industrial Engine Crankshaft - Remove
C4.4 Industrial Engine Electric Starting Motor - Remove and Install
C4.4 Industrial Engine Electronic Control Module - Remove and Install
C4.4 Industrial Engine Electronic Unit Injector - Remove
C4.4 Industrial Engine Electronic Unit Injector - Install
C4.4 Industrial Engine Engine Oil Cooler - Install
C4.4 Industrial Engine Engine Oil Cooler - Remove
C4.4 Industrial Engine Engine Oil Filter Base - Remove and Install
C4.4 Industrial Engine Engine Oil Pan - Remove and Install - Cast Iron Oil Pan
C15 On-Highway Engine Alternator Mounting
C4.4 Industrial Engine Engine Oil Pan - Remove and Install - Aluminum and Pressed Steel Oil Pans
C4.4 Industrial Engine Engine Oil Pressure Sensor - Remove and Install
C4.4 Industrial Engine Engine Oil Pump - Remove and Install - Engines Without a Balancer Unit